14 problems related to seat belt have been reported for the 2003 Toyota Camry. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2003 Toyota Camry based on all problems reported for the 2003 Camry.
Driver seat belts releases on its own especiall while driving. I stop and push metal clasp back into position, sometimes with force to make sure it is engaged. Sometimes it stays in place, sometimes not. I also check to make sure nothing is in the way of metal clasp before pushing it into the slot. I never know when it will pop back again undtil the light on the dashboard starts to flash. This has been going on for about 2 months.
The seat belt comes unfastened when driving down the street. This happens several times a week. You can pull and pull on the belt and it remains locked, but while traveling on the road, especially if one hits a bump, the belt unlatches and the light comes on and buzzer sounds. Went to junk yard to get a different latch and learned that their neighbor's 2003 Toyota Camry does the same thing. This needs to be investigated and fixed. Found same complaint on several complaint boards.
My seatbelt won't click into the buckle and or release on their own has been happening for a couple of months and then have it eventually stopped working completely I cannot buckle my driver seat belt and one of the rear passenger seat belts has started doing the same thing I am about to go to the dealership and have them replaced before I get into an accident I would hate to find out that the seatbelt that does work now stopped working with my child in the car in an accident.
The seat belt buckle releases intermittently while driving every day trip and all the time for the past few months, when I put it on I redo it over and over until it latches properly. This happens every time I try to latch it.
My seatbelt buckle button doesn't want to release the seatbelt when I went to Toyota dealership, they said it not cover under safety. I have to paid for repair.
Driver's side seat belt does not retract at any time.
Seatbelt won’t click into the buckle and or release on their own has been happening for a couple of years and then have it eventually stopped working completely I cannot buckle my driver seat belt.
Can't take my kids anywhere because it not safe can't gave friend ride . Cause it un safe this car is un safe please can fit my car when I got car did no it had problems with bags. . My right side dash has line across it bust open. C.
Tl - the contact owns a 2003 Toyota Camry. The contact stated that the front passenger seat belt buckles failed preventing the seat belt to be secure properly. The vehicle was taken to the dealer. The technician diagnosed that both the passenger and driver seat belt buckle needed to be replaced. The manufacturer was made aware of the failure. The vehicle was not repaired. The failure mileage was 345,754 and the current mileage was 345,800. Pm.
Driver airbag failed to deploy when the vehicle was involved in frontal passenger side crash. This crash was severe enough to destroy front bumper, headlights, hood, passenger side fender, wheel/ tire. The vehicle was total loss. The driver sustained severe injuries to face & eyes with several facial fractures, broken nose when face impacted the steering wheel. Updated 12-13-13 updated 12/18/13.
Seat belt appears to be latched but isn't always.
The driver's side seatbelt no longer unlatches. The problem initiated with difficulty getting the free end component to lock into the receiving end.
Drivers side seat belt buckle. The spring broke in the seat belt buckle where it clicks in and seat belt won't stay fastened. Safety issue.
I have a 2003 Toyota solara convertible. My seat belt would lock up on me on a regular basis and have to work at it to loosen it from my neck. - this has happen several times. It was so bad I had to manually roll the seat belt back into the holder every time I got out of the car for the past year and a half. Finally the other day it just wouldn't roll back in at all, so it was pulled out all the way and would not roll in. I had to take get an entire new mechanism and set belt installed. This cost is over $400. 00 to replace I really feel that this is a safety defect. I had a Chrysler for over 13 years and never had a problem with a seat belt, in fact I also have a 1992 gm and have never had a problem with the seat belts.