Two problems related to electrical jack have been reported for the 2012 Toyota Camry. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2012 Toyota Camry based on all problems reported for the 2012 Camry.
I purchased the car from a dealership in jacksonville, florida. After I signed papers and wanted to take the car home I have noticed a sticker closed to the drivers door, it says Toyota motor corporation, authorized modification, the following modifications has been made (and then with a red marker it is written dot recall) and underneath of it continue, these modifications have been approved as appropriate by epa and carb. Dealer code 09231. Date 3/19/14. I do not know what this means, was car on recall by dot and was/were the issue/issues resolved or not. Can you help. Contact me at 904-345-9096.
Flat tire in home garage. Oe pantograph (scissor) jack was used in attempt to raise car. Excessive torque was necessary to begin lift, up to limit of flimsy jack handle. As vehicle neared top of necessary lift, jack flipped over sideways and was propelled out from under car with some force. Car fell. No injury or damage because I observed all safety precautions while lifting. Jack is flimsy, too small for the car, and has much too small a base. This occurred on level concrete floor. Markings on jack include: 2j141, 2012, and made in canada.