Bumper problems of the 2025 Toyota Camry

The contact owns a 2025 Toyota Camry. The contact stated that after a visual inspection of the exterior of the vehicle, the contact became aware that the front bumper cover had detached. The vehicle was taken to the dealer, who diagnosed a failure with the bumper fasteners. The vehicle was repaired, but the failure reoccurred. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA hotline for assistance. The failure mileage was unknown.

1. The driver-side bumper/bumper cover and/or bumper attachment clips, brackets, or mounting points failed or malfunctioned. The bumper was protruding on the driver’s side and was not staying properly secured to the vehicle. Repairs have already been completed by an independent auto body shop. I have repair documentation, photos, and/or invoices available to support the complaint. 2. My safety and the safety of others were put at risk because the bumper was protruding and not properly secured on the driver’s side. I was concerned that the bumper could become further detached while driving, especially at highway speeds, creating a road hazard for other drivers or pedestrians. The protruding bumper could also affect the vehicle’s exterior safety structure, cause distraction while driving, or worsen if the vehicle hit a bump, pothole, or experienced normal road vibration. 3. Yes. The problem was confirmed by an independent auto body shop. They inspected the bumper issue and repaired it. I was also advised by the shop that they have seen similar issues with Toyota bumpers and that this appears to be a common problem. The repair cost was approximately $1,000 out of pocket. 4. The vehicle/component was inspected by an independent auto body shop. To my knowledge, it has not yet been inspected by Toyota, police, or insurance representatives. I am filing this complaint so the issue can be documented and reviewed as a possible safety or manufacturing-related concern. 5. There were no warning lamps or dashboard messages related to this issue. The main symptom was visible: the bumper began protruding on the driver’s side and was not staying properly attached. I first noticed the issue on or around June 10, 2025. The condition appeared to worsen or remain unresolved until I had it repaired by an independent auto body shop. I am filing this complaint regarding a bumper issue on my Toyota vehicle. The driver-side bumper/bumper cover began protruding and was not staying properly.

The front bumper of the vehicle has a known issue where the bumper isn’t staying in properly causing the bumper to pop out of alignment. Toyota fix is to heat up both sides of the plastic edges and tuck the bumper underneath the headlights. It’s a temporary fix that’s needs to be rectified. It seems like Toyota changed the Camry design before it was ready.