Table 1 shows one common service brakes related problems of the 2022 Toyota Corolla.
| Problem Category | Number of Problems |
|---|---|
| Service Brakes problems |
Epb shift interlock function activated message on the dashboard briefly before start-up. This has occurred even though the car hasn't had any issues before. The braking system is functional, except regardless of time and temperature, the message still displays. The car's battery is in good condition and no low power level is displayed.
M car was towed to Toyota because my automatic parking brake failed to release. No warning lights nor any indication my battery was low. It licked my rear wheels so I could not drive. (thank god I was not in a fire zone requiring evacuation!) there are no manual release for the emergency brake to use in an emergency to flee an area. They said my battery was not carrying the load, and replaced it. This is a very serious safety issue! what if it was a Sunday and Toyota closed?? most repair shops are closed on sundays! I’m [xxx] and [xxx]. Please advise Toyota to add or retrofit a manual parking brake release to resolve this issue. And…. Check to make sure their analysis was correct that my battery was too low! information redacted pursuant to the freedom of information act (foia), 5 u. S. C. 552(b)(6).
The contact owns a 2022 Toyota Corolla. The contact stated that while attempting to reverse, the message “automatic brake not available” was displayed on the instrument panel. The vehicle was towed to a dealer where it was diagnosed and determined that the battery needed to be replaced. The vehicle was repaired but the failure persisted. The manufacturer was notified of the failure and a case was opened. The failure mileage was 36,000. The VIN was not available.
I drive under the acc system, the front traffic slows down on highway, but acc system do not automatically slows down. So I push the brakes, but the car didn't slow down either. The car crash directly into the front car. Currently the car is under insurance inspectation. After the crush happened, the car start automatically moving without engine on, when it's in the parking mode. An police officer stop the car from moving by manually push the car backwards.
Rotors over heat causing the brakes not function properly and not able to break on time. Loud grinding noise when lightly tapping on breaks.
Overheating rotors, had to replace brakes twice in less than 2 years. This can cause an accident.
Brake rotors have warped twice in less than 50,000 miles. Brakes also become easily overheated a brake fade occurs if diving in hilly/ mountainous terrain.
The contact owns a 2022 Toyota Corolla. The contact stated that the steering wheel, the brake pedal and the front end of the vehicle were shuddering significantly when depressing the brake pedal. The contact stated that the failure occurred while driving and while at a complete stop. The vehicle was taken to the dealer, where it was determined that the front rotors needed to be resurfaced. The dealer resurfaced the front rotors and the failure stopped. The contact stated that the failure later recurred. The vehicle was taken back to the dealer, where the same assessment made. The vehicle was not repaired. The manufacturer was notified of the failure, but no assistance was provided. The failure mileage was unknown.
The contact's mother owns a 2022 Toyota Corolla. The contact stated while his mother was driving 5 mph and was depressing the brake pedal but failed to stop the vehicle and crashed into a 711 building. The contact stated no warning light was illuminated. No air bags deployed. The driver stated she had back pains but declined any medical service when the police officer asked. A police report was filed. The driver took the vehicle to a body shop and reattached the front bumper. The driver took the vehicle to the local dealer a week later and made aware of the failure. The vehicle was not diagnosed or repaired. The manufacturer had been informed of the failure. The failure mileage was approximately 21,000.
Crashed.
The auto services said "rotor to have a rust on them causing vibration" but I think there are additional situation because they needed the rotors to be machined.