Table 1 shows one common power train related problems of the 2023 Toyota Sequoia.
| Problem Category | Number of Problems |
|---|---|
| Power Train problems |
Electronic control module failed due to the cup holder failing. It is available for inspection. Safety was put at risk because the vehicle randomly slammed itself on the brakes, when in drive the vehicle was moving backwards then abruptly braking and moving forward. The problem was confirmed by the dealer. There were warning lamps for the following: drive start control malfunction, parking brake unable to disengage, hybrid system failure, check engine, parking support brake malfunction. The vehicle was showing as being in both park and drive at the same time. The dealer determined the cupholder allows water condensation to leak into the center console compartment where exposed high and low voltage wiring is contained as part of electronic modules causing the vehicle to malfunction. The vehicle was put in gear while throwing the malfunctions, however, the electronic components should not be exposed and stored within a compartment where liquids are known to be stored (cup holder) in a way that allows water to leak into them. This could happen while the vehicle is being driven and cause serious issues. This same issue happened once before several months back before the cup holder started to fail, so regardless if the cupholder is working properly, it seems water can penetrate this area of the vehicle and cause issues because there is no barrier between the electronic modules/wiring and the cup holder drip tray. The service department actually stated to me that they see this issue all the time on the Sequoias and tundras.
Hybrid system malfunctioned and engine completely seized up. Dealer/Toyota is replacing the short block and both turbos on my Sequoia. This seems to be the same issue as the tundra engines.
Vehicle vibrates above 45mph. Took it to dealership and they did not fix the issue. Lane departure warning had to be disabled as it is mistaken for an actual lane departure. Vehicle posses a risk to operator and other drivers on the roadway. Toyota corporate notified but disregarded claim as dealership advised they were unable to replicate.
Vibration caused by unbalanced drive shaft. It’s made of aluminum and after only 2136 miles it’s already unbalanced and shakes when moving. This is the third vehicle I’ve seen do this after only a few thousand miles of use.