Vehicle Shudder problems of the 2007 Toyota Tacoma

My chasys frame have rust and look like my motor going to fell to the floor I call Toyota but the say no open recall to replace my frame, also my car have a lot vibration on rear went aceleration. But Toyota dont wante help.

Moderate to severe vibration started from 5-40 mph then vibration is still there at > 40mph but not as bad. Does not matter is hot or cold, city or highway I had tires balanced and rotated but vehicle still vibrates. TSB's from Toyota point to drive train vibrations in Tacoma models. Now, at times, the drive train squeals like a bad u-joint or hanger bearing. Dealer said they are aware but no recall. This needs a recall. Vehicle has around 147000 miles.

At first about 6 months ago , car started vibrating at low speed and disappear at higher speed. On 3/13/14 traveling a about 30mph , there was a sudden vibration (car shaking violently ) then a loud bang underneath the driver side. Glided the car along side the road, did a visual inspection under the car and notice the front propeller shaft was hanging there. My truck has been expose to carrying heavy load. The heaviest load that this truck carried was an upright freezer that I bought from k-mart. Is my truck included in that 2007 for drivetrain problem??? if so where can I get info on this? my problem is very similar to the 2007 recall on bad casting.

2007 Toyota Tacoma. Consumer writes in regards to sudden vibration when vehicle was at a stop. The consumer stated the vehicle would idle really low. When he turned on the ac, the idle would increase and the truck would stop vibrating. Also, if he put the vehicle in neutral, the rpm would increase and it would stop vibrating. The consumer stated he checked under the vehicle, but didn't see any visual leaks. As he proceeded to slide from under the truck, the front tire rolled over his head and chest. The truck rolled across the street and hit a street sign. The consumer stated he and a friend re-created the incident. The consumer stated when the friend touched a linkage, he saw the shifter move toward the back of the truck, staying in the slot for park. The truck then rolled while making a clicking noise. The consumer applied the brake and the truck stopped, he pushed the shifter forward and the truck re-engaged into park. The consumer stated he could only re-create the problem, when the vehicle was parked on an incline. The consumer stated when the vehicle was parked on a slight incline, it had the ability to pop out of park by slightly touching the linkage under the truck. Updated 07/23/lj.

The contact owns a 2007 Toyota Tacoma. The contact stated that he shifted into drive and the rear end of the vehicle began to shake abnormally. The contact took the vehicle to the dealer for inspection where they stated that the cone on the rear end needed to be replaced. The vehicle was repaired but the failure recurred. The manufacturer was notified of the issue and stated that there was nothing they could do to assist. The failure mileage was 5,000.

The contact owns a 2007 Toyota Tacoma. While driving approximately 30 mph, the vehicle would vibrate excessively. While idling, the vehicle would dramatically jerk forward. The failures grew progressively worse when the brakes were applied. The dealer stated that nothing was wrong with the vehicle; however, they replaced three tires. Immediately after the repair, the failure recurred and the vehicle stalled and then restarted immediately. He took the vehicle to a different dealer, but they would not perform an inspection. He filed a formal complaint with the manufacturer. The failure mileage was 1,200 and current mileage was 15,631.