Technical Service Bulletins of the 2013 Can-am Spyder Rs
There have been 19 technical service bulletins issued for the 2013 Can-am Spyder Rs.
1
2013 Can-am Spyder Rs cooling system TSB (Bulletin 87480)
Bulletin Date:
Sep. 25, 2015
Component:
Cooling system.
Bulletin Summary:
Technical service tip (tst): customer may complain of excessive heat felt on the lateral panels in certain riding conditions. Solution is to install the air scoop panel kit. Make sure the unit has the 2013-9 warranty campaign ecm update pe
New evap purge valve line execution. As an improvement to the evaporative emission system (evap), brp just released a new evap purge valve line execution.
3
2013 Can-am Spyder Rs exhaust system emission control TSB (Bulletin Bulletin 2015-7)
Bulletin Date:
Aug. 27, 2015
Component:
Exhaust system emission control.
Bulletin Summary:
New evap purge valve line execution. As an improvement to the evaporative emission system (evap), brp just released a new evap purge valve line execution.
Technical service tip (tst):instruction to be followed if a customer complains of excessive heat felt on the lateral panels in certain riding conditions. The solution is to make sure the unit has the 2013-9 warranty campaign ecm update perf
Revison 1 of warranty bulletin 2013-9 adressing 3 problems: a) seal the front fuse boxes because water may infiltrate either of the front fuse boxes; b) update ecm software because code p1614 may be triggered and cause a limp home mode when
Revison 1 of warranty bulletin 2013-9 adressing 3 problems: a) seal the front fuse boxes because water may infiltrate either of the front fuse boxes; b) update ecm software because code p1614 may be triggered and cause a limp home mode when
Revison 1 of warranty bulletin 2013-9 adressing 3 problems: a) seal the front fuse boxes because water may infiltrate either of the front fuse boxes; b) update ecm software because code p1614 may be triggered and cause a limp home mode when
Posting about some units stalling at idle when coming to a stop with the drive train disengaged. The occurrence will be reduced with time and eliminated after the performance of the 1st maintenance or as the engine brake-in is completed.
Posting about some units stalling at idle when coming to a stop with the drive train disengaged. The occurrence will be reduced with time and eliminated after the performance of the 1st maintenance or as the engine brake-in is completed.
Technical service tip (tst) addressing that in order to properly investigate a soft suspension complaint, provide the information listed to the brp technical support team.
Warranty bulletin addressing the problem that some units left the factory with the wheel alignment out of the specification. The solution is to verify the wheel alignment and, if necessary, adjust it according to the improved procedure.
Warranty bulletin addressing the problem that some units left the factory with the wheel alignment out of the specification. The solution is to verify the wheel alignment and, if necessary, adjust it according to the improved procedure.
Warranty bulletin addressing the problem that some units left the factory with the wheel alignment out of the specification. The solution is to verify the wheel alignment and, if necessary, adjust it according to the improved procedure.
20
2013 Can-am Spyder Rs front suspension control arm lower ball joint TSB (Bulletin BULLETIN 2013-1)
Bulletin Date:
Feb. 26, 2013
Component:
Front suspension control arm lower ball joint.
Bulletin Summary:
Warranty bulletin addressing the problem that some vehicles have been produced using front suspension lower arm ball joints with too high friction that may affect the dynamic driving performance and the customer satisfaction. The proposed s