Technical Service Bulletins of the 2013 Can-am Spyder St
There have been 23 technical service bulletins issued for the 2013 Can-am Spyder St.
1
2013 Can-am Spyder St cooling system TSB (Bulletin 87480)
Bulletin Date:
Sep. 25, 2015
Component:
Cooling system.
Bulletin Summary:
Technical service tip (tst): customer may complain of excessive heat felt on the lateral panels in certain riding conditions. Solution is to install the air scoop panel kit. Make sure the unit has the 2013-9 warranty campaign ecm update pe
Technical service tip (tst) related to clutch engagement which could chatter or shutter.
Vehicles covered in this TSB:
2013 Can-am Spyder Rs, 2013 Can-am Spyder St.
3
2013 Can-am Spyder St fuel system diesel pre-heater TSB (Bulletin ARTICLE 87480)
Bulletin Date:
Sep. 12, 2014
Component:
Fuel system diesel pre-heater.
Bulletin Summary:
Technical service tip (tst):instruction to be followed if a customer complains of excessive heat felt on the lateral panels in certain riding conditions. The solution is to make sure the unit has the 2013-9 warranty campaign ecm update perf
Technical service tip (tst): brp has received reports concerning the brake light staying lit when the brake pedal is resting on the bump stop. This will cause battery drainage. There are 2 reasons the brake light switch may not operate corr
Vehicles covered in this TSB:
2013 Can-am Spyder St.
5
2013 Can-am Spyder St fuses and circuit breakers TSB (Bulletin SB-2013-0015)
Bulletin Date:
Apr. 9, 2014
Component:
Fuses and circuit breakers.
Bulletin Summary:
Brp: front fuse boxes seal allows water to infiltrate; when engine has started can cause code p1614 to be triggered and home limp mode; the belt guard retaining screws are not secured properly.
6
2013 Can-am Spyder St equipment adaptive TSB (Bulletin SB-2013-0015)
Bulletin Date:
Apr. 9, 2014
Component:
Equipment adaptive.
Bulletin Summary:
Brp: front fuse boxes seal allows water to infiltrate; when engine has started can cause code p1614 to be triggered and home limp mode; the belt guard retaining screws are not secured properly.
7
2013 Can-am Spyder St software TSB (Bulletin SB-2013-0015)
Bulletin Date:
Apr. 9, 2014
Component:
Software.
Bulletin Summary:
Brp: front fuse boxes seal allows water to infiltrate; when engine has started can cause code p1614 to be triggered and home limp mode; the belt guard retaining screws are not secured properly.
8
2013 Can-am Spyder St (pws) TSB (Bulletin SB-2013-0015)
Bulletin Date:
Apr. 9, 2014
Component:
(pws).
Bulletin Summary:
Brp: front fuse boxes seal allows water to infiltrate; when engine has started can cause code p1614 to be triggered and home limp mode; the belt guard retaining screws are not secured properly.
9
2013 Can-am Spyder St engine gasoline belts and associated pulleys TSB (Bulletin BULLETIN 2013-9 )
Bulletin Date:
Apr. 1, 2014
Component:
Engine gasoline belts and associated pulleys.
Bulletin Summary:
Revison 1 of warranty bulletin 2013-9 adressing 3 problems: a) seal the front fuse boxes because water may infiltrate either of the front fuse boxes; b) update ecm software because code p1614 may be triggered and cause a limp home mode when
10
2013 Can-am Spyder St fuses and circuit breakers TSB (Bulletin BULLETIN 2013-9 )
Bulletin Date:
Apr. 1, 2014
Component:
Fuses and circuit breakers.
Bulletin Summary:
Revison 1 of warranty bulletin 2013-9 adressing 3 problems: a) seal the front fuse boxes because water may infiltrate either of the front fuse boxes; b) update ecm software because code p1614 may be triggered and cause a limp home mode when
Revison 1 of warranty bulletin 2013-9 adressing 3 problems: a) seal the front fuse boxes because water may infiltrate either of the front fuse boxes; b) update ecm software because code p1614 may be triggered and cause a limp home mode when
12
2013 Can-am Spyder St unknown or other TSB (Bulletin SB-2013-9)
Bulletin Date:
Feb. 21, 2014
Component:
Unknown or other.
Bulletin Summary:
Brp: on some motorcycles, the upper belt guards are falling off due to the torx screws being short and not able to reach nylon of nut.
Vehicles covered in this TSB:
2013 Can-am Spyder St.
13
2013 Can-am Spyder St fuses and circuit breakers TSB (Bulletin SB-2014-0001)
Bulletin Date:
Jan. 23, 2014
Component:
Fuses and circuit breakers.
Bulletin Summary:
Brp: on some motorcycles, need to have the front fuse box covers replaced with an improved cover in production and also, update ecm software (p1614, hi temp lamps, limp home mode).
Vehicles covered in this TSB:
2012 Can-am Spyder Rs, 2013 Can-am Spyder St.
14
2013 Can-am Spyder St software TSB (Bulletin SB-2014-0001)
Bulletin Date:
Jan. 23, 2014
Component:
Software.
Bulletin Summary:
Brp: on some motorcycles, need to have the front fuse box covers replaced with an improved cover in production and also, update ecm software (p1614, hi temp lamps, limp home mode).
Vehicles covered in this TSB:
2012 Can-am Spyder Rs, 2013 Can-am Spyder St.
15
2013 Can-am Spyder St fuses and circuit breakers TSB (Bulletin WC-2013-9)
Bulletin Date:
Jan. 23, 2014
Component:
Fuses and circuit breakers.
Bulletin Summary:
Can-am motorcycle: warranty campaign information regarding seal of front fuse boxes (water infiltrating either of front fuse boxes), updating ecm software (a limp home mode may be triggered when engine has started, replace upper belt guard
16
2013 Can-am Spyder St frame and members TSB (Bulletin WC-2013-9)
Bulletin Date:
Jan. 23, 2014
Component:
Frame and members.
Bulletin Summary:
Can-am motorcycle: warranty campaign information regarding seal of front fuse boxes (water infiltrating either of front fuse boxes), updating ecm software (a limp home mode may be triggered when engine has started, replace upper belt guard
17
2013 Can-am Spyder St software TSB (Bulletin WC-2013-9)
Bulletin Date:
Jan. 23, 2014
Component:
Software.
Bulletin Summary:
Can-am motorcycle: warranty campaign information regarding seal of front fuse boxes (water infiltrating either of front fuse boxes), updating ecm software (a limp home mode may be triggered when engine has started, replace upper belt guard