This design change of the idler gear case and idler gear bolt is to address the idler gear bolt loosening under abnormal loading from fuel supply pump and the gear train. The redesigned idler gear case and idler gear bolt are designed to
176 updated speedkometer conversion rate procedure. 2008-2010 model year conventional trucks. The tech tip is to use with the updated cable and dx2 for changing the speedometer conversion rate. Please note that an updated cable can be provi
New parts are available to prevent repeat exhaust manifold stud failures on the j05 engine. This bulletin provides instructions for an exhaust manifold attachment modification at the #1 and #4 cylinder locations. Modifications to the manifo
5
2010 Hino Conventional Models power train TSB (Bulletin SB-15-015)
Bulletin Date:
Feb. 12, 2015
Component:
Power train.
Bulletin Summary:
Addition of the troubleshooting procedure for engine lacked power during the dpr automatic regeneration. Releva nt manuals: hino 145, 165, 185, 238, 258, 268, 308 and 338
P2002 dpr system malfunction (2-digit diagnosis codes) in the event that dtc dp2002 - dpr ( diesel particulate reduction) system malfunction sets in the enginef ecu (ddsengine control unit), additional diagnostic information is provided thr
P2002 dpr system malfunction (2-digit diagnosis codes) in the event that dtc dp2002 - dpr ( diesel particulate reduction) system malfunction sets in the enginef ecu (ddsengine control unit), additional diagnostic information is provided thr
When replacing an engine block with service part no. , 11401e0380 there is potential that 2 rear oil passage plugs may be missing in the rear of the replacement engine block. In the event your replacement engine block does not have these 2 o
A subject vehicle at 200,000 miles may exhibit a ?dpr maintenance? message displayed on the instrument cluster message center. The following procedure will instruct how to check the dpf and reset the displayed message.
10
2010 Hino Conventional Models lane departure TSB (Bulletin SB-14-017)
Bulletin Date:
Sep. 4, 2014
Component:
Lane departure.
Bulletin Summary:
In the event that one of the subject vehicles is driven while the abs warning lamp is illuminated, operation of the torque converter clutch will be suspended. Driving the vehicle with an abs warning lamp illuminated can lead to overheating
11
2010 Hino Conventional Models power train TSB (Bulletin SB-14-017)
Bulletin Date:
Sep. 4, 2014
Component:
Power train.
Bulletin Summary:
In the event that one of the subject vehicles is driven while the abs warning lamp is illuminated, operation of the torque converter clutch will be suspended. Driving the vehicle with an abs warning lamp illuminated can lead to overheating
This procedure illustrates a worst case scenario repair procedure, the process and materials being used are the same for all repairs. Depending on the location of the repair, access may be limited in some cases. Ensure that the repair area
The following information applies to the installation of a customer supplied and commercially available electric trailer brake controller for all 2008my-2015my hino trucks. This application only applies to brake controllers which operate us
The following information applies to the installation of a customer supplied and commercially available electric trailer brake controller for all 2008my-2015my hino trucks. This application only applies to brake controllers which operate us
The following is to inform you of the revision of the inspection procedure for the dtc?s p0340 and p0341. You are kindly requested to attach this service data to the relevant pages of the workshop manuals for maintenance and to use for serv