Steering Tie Rod Assembly problems of the 2000 Buick Century

Five problems related to steering tie rod assembly have been reported for the 2000 Buick Century. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2000 Buick Century based on all problems reported for the 2000 Century.

1 Steering Tie Rod Assembly problem

Failure Date: 05/09/2003

When the consumer had the tires rotated the mechanic noticed that the front outer tie rods were loose and needed to be replaced.

2 Steering Tie Rod Assembly problem

Failure Date: 07/26/2002

Vehicle was in for a routine check when mechanic noticed right front tie rod end was worn. Cause unknown. Please provide any further information.

3 Steering Tie Rod Assembly problem

Failure Date: 05/12/2002

2000 Century limited. . . . . 20,340 mile bought new. Noise from the engine (lifters) is getting louder and the front end is pounding. I see that the tie rods are bad, the rack is sloppy the brakes and rotors have failed due to chinese materials. The car is garaged, maintained and taken care of. The hydraulic brakes line have failed and had to be replaced. Presently owning 12 gm cars right now,this car is falling apart. It has the v-6 engine that has gotten 35 mpg on a trip (if it makes it).

4 Steering Tie Rod Assembly problem

Failure Date: 01/01/1901

On two occasions the steering wheel felt loose and the driver heard a clink noise while driving. The dealer later determined that one of the tie rods broke. The dealer replaced the tie rod, aligned the tires and balanced the tires.

5 Steering Tie Rod Assembly problem

On two occasions steering wheel felt loose, and driver heard a "clink" noise while driving. Both times dealer found that the tie rod broke. Dealer replaced the tie rod, aligned, and balanced the tires.


Other Steering related problems of the 2000 Buick Century



Fuel Economy of Century Vehicles
Century Service Bulletins
Century Safety Recalls
Century Defect Investigations