Steering Idler Arm problems of the 1999 Chevrolet Blazer

: the contact stated while driving at any speed the vehicle became loose in the steering and a popping noise was heard. The vehicle was taken to an independent repair shop for inspection. The dealer determined the idle arm needed replaced. The idle arm has been replaced three times in 6 months. Updated 4/11/2006 -.

Problems with vehicle's wheel bearing, front idler and pitman arms. The consumer replaced the left front wheel bearing which required the replacement of the entire hub kit. The right front bearing failed as well, along with the right front idler and pitman arm.

Vehicle was pulling to side and steering wheel had too much play. Dealer replaced idler arm. Did not remedy the problem. On 10 April 2002 right front upper and lower ball joints were replaced. Reported by david bluman.

Front wheel hub on on front driver and passenger side had to be replaced several times due to a grinding noise when driving. Idler arm and ball joint were also replaced.