Transmission Solenoid problems of the 2011 Chevrolet Equinox

It only had 42000 miles on it and even before it sounded funny. We had it hooked to diagnostic and it said the intake and exhaust cam shaft actuator solenoids needed to be replaced or faulty. Google it online it comes up as a recall for my year of 2011 chevy equinix. But when I told them at chevy service center they were addiment that only certain vins and thats what they go by. But I told them how would you know which ones are affected if your not told by consumers. Online and on different sites come up that some have problems and have recalls . Well om informing them that theres an issue but since its not on their data base or my VIN they will not do anything. The car when driving shuts off sometimes. Or when I start it and begin to drive it shuts off.

Tl the contact owns a 2011 Chevrolet Equinox. While making a left turn, the vehicle lost acceleration. The contact had to depress the accelerator pedal four times before the vehicle accelerated. In addition, when making a right turn, the vehicle failed to accelerate. However, when driving straight ahead, the vehicle accelerated normally. The contact coasted the vehicle into a parking lot and powered off the engine. The vehicle was restarted and was able to drive normally, but only when driven straight ahead. The vehicle was taken to conklin Chevrolet newton (located at 1500 se 3rd st, newton, KS 67114, (316) 842-4137) and the failure was duplicated. The dealer ordered a solenoid pack and replaced the old one; however, the failure recurred. The dealer test drove the vehicle and it failed to accelerate even when driving straight ahead. The vehicle was later towed to conklin cars Buick GMC hutchinson (located at 1400 e 11th Ave, hutchinson, KS 37501, (620) 708-4102) where it was diagnosed that the wave plate exploded and sent metal pieces inside the metal case, which damaged the transmission. The dealer stated that the transmission needed to be replaced. The vehicle was repaired. The manufacturer was notified of the failures and provided case number: 9-5288717276. The approximate failure mileage was 91,754.

Gm recall 11195a - poor drivability/ safety/ emissions recall for camshaft position actuator solenoids. My 2. 4l 2011 Equinox (approx. 47,000 at purchase 11/16 & 71,000 current) is now at days Chevrolet in acworth GA. Due to 1) shutting off multiple times while driving, 2) stalling at idle (fwd & rev). I initially visited days on 12/22/17 to start an oil consumption test related to 15285c, as my car presented with stalling/hesitation/surging and loss of 3 qts oil. As of today (1/3/18), I returned to days when it shut off while driving again. The dealership's diagnosis is intake & exhaust camshaft solenoid failure. I suspected this based on code p0010 recorded by my diagnostic unit. So I got a rental, left my car for the camshaft repairs, and researched recalls. The 2011 2. 4l has many known engine/powertrain/safety issues. Lo and behold, I found the recall on the camshaft diagnosis. It reads exact to what I'm experiencing. My next step was contacting days to ask why I'm being charged for a recalled repair. I was informed that they were unaware of recall 11195a. My service advisor, rob, looked up the recall and discovered that there is in fact a recall for the exact diagnosis, yet could not explain why my VIN is not included. He advised that the car is exhibiting exactly what the recall is issued for and that it's clearly a known safety issue, yet gm will not cover my repair because "the VIN is not included". I very much believe this is gm's responsibility and gm should cover the repair at no cost because it's a result of their faulty engineering. I contacted gm customer service tonight and was told there's nothing gm can do. I strongly disagree. Gm can do the right thing. I requested a case be opened and was given #83734190593 after pressing (paul) for one. In the end. Gm was of no help and my VIN is still in limbo, so I'm filing my complaint here.

Stalling out while sitting in drive at red light. Got up for work and turned truck on, sounded very rough. Put truck in reverse and took off and when stopping at a red light the rpms would move on their own, car starts bouncing, motor is rattling, and sometimes stalls out. I have to put the truck in neutral at every light for it to not rock back and fourth. Next day check engine light came out, readings indicated it was the throttle sensor body and the solenoids. I replaced all of these and truck is still running the same, and check engine light is still on. After doing research I have read well over 50 of the same complaint of these vehicles doing the same thing! we need help!.

In Jan 5 2016 my 2011 chevy Equinox mileage 56747 would just stall without warning and I had no control of steering. Driving on the hwy it just killed and started but didn't want to accelerate again then stalled again couldn't steer. Got it to ray Chevrolet it was my camshaft position actuator solenoid valve in sept. 2016 mileage 80584 I had it towed again and it was the camshaft position actuator solenoid valves and it burnt my electronic control unit aka computer which cost me $800. 00. Skipping forward but not without problems there are many. Aug. 2019, I am having to change camshaft position actuator solenoid valves again do to stalling on the road while I'm driving not being able to steer for the third time. It's so dangerous to drive this car without warning it will kill on you for a number of reasons. Then I went change my oil like clock work and was told I have a valve cover gasket leak to go with the solenoid problem. It's so dangerous to drive due to the fact it will stall at anytime. In Aug. 2019 my pressure sensor for my right tire went out. Now I can't get it to reset and mechanic tried and said sensor needs to be changed really. I can't tell if I have a low tire it just shows blank line on all tires. Now my actuator bend door broke on defrost and it's hot in louisiana. Almost impossible to get to. This car needs a recall really bad. There is never a time where the car just ran good with no trouble. Things that broke on this car are listed below. Air control iac value, actuator bend door, valve cover gasket, computer, pressure sensor, cv joints, intake & exhaust camshaft position actuator solenoid <>three times.

Initially the issue started with rough idling of the car, engine ticking, and engine stalling. After indicating this to the dealership, they informed me that the ecm needed to be reprogrammed because the oil life indicator was not properly calibrated causing the system to think that there was more life on the oil than there actually was. The engine balance chain eventually broke while on the interstate (55 mph), due to improper oil lubrication. The fuel pump, water pump, and a few other items had to be replaced due to the damage caused when the chain broke. I notified the dealership once again after engine ticking/ rough idling re-occured and they indicated to me that the engine ticking during startup was normal. The engine ticking progressed to becoming a constant noise. I noticed that when I took the oil in for an oil change, approximately 2000 miles in, that the oil dipstick would come up completely dry. This indicated the vehicle was experiencing an excessive amount of oil consumption. I took the vehicle to the dealership who indicated that pistons had to be replaced and the exhaust manifold was cracked. This indicated that the engine was observing some excessive amount of heat most likely due to the oil consumption issue. During these issues, no service engine light ever came on. The car had to be taken back to the dealership after the service engine light came on which indicated that the cam shaft actuator solenoids and catalytic converter needed to be replaced. The catalytic converter most likely failed due oil seeping into the exhaust which coated the ceramic substrate & the excessive heat experienced by the engine (as indicated by the cracked manifold) damaged the ceramic substrate. Oil consumption leads to excessive heat from the engine which can be a fire hazard. Engine stalling due to oil consumption leads to crash safety issues.

Cruising along at 65 mph on highway when service stabilitrak light along with reduce engine power came up on the dash. I lost engine power and went from 65 mph to 15 mph. I was able to pull onto an exit ramp. I quickly pulled over & parked the car. Shut the car off & waited about 1 min & turned the car back on. The stabilitrak & the reduce engine power cleared off my dash but the check engine light stayed on. Then was able to merge back into traffic & pick up the 65 mph speed. I was worried that it would happen again when I had to cross oncoming traffic. When I got in my car later, the service engine light had even turned off, but on the way home it happened again. Took it to the shop and was told it was a throttle body/solenoid issue & that it needs replaced. They told me it isnt covered under the pt warranty. As others have also said, I'm seeing a number of people with this same issue & wondering why this isnt a recall? it's very unsafe especially cause you dont know when its going to happen. If your doing 65-70 mph on a highway & there are cars close to you & the vehicle decides to do this, you and your family are going to get killed.