Brake Sensor problems of the 2010 Chevrolet Malibu

Had camshaft sensor installed less than a year ago and engine came on with same sensor code. The electrical system is going out constantly and headlight bulb was repaired 4 times less than a year. Cost me over 600 total one service was done for free because it was repaired and blew the next day. So much work and barely drive to car to and from work only 2 miles. I plan to make a complaint to the attorney general for explanations if not solved or reimbursed. The vehicle stays in the shop more than use. Traction control sensor replaces and came back 2 weeks later. The vehicle also stalled with my children on a busy street where a vehicle almost struck the back side missing my daughter by inches. Unsafe vehicle and too many malfuctions.

My 2010 chevy Malibu is having issues with the break lights working in reverse, the esc traction control sensor is going off. We have replaced the break light switch and it's still not working. I have seen multiple complaints regarding this issue. I am an avid chevy person, I have had the car in for all recalls and it happened about a year after. Car was in motion.

Tl- the contact owns a 2010 Chevrolet Malibu. The contact stated that the brake exterior lights are illuminating independently which affected the cruise control, abs braking system, and is difficult when shifting the vehicle out of park. The failure happened without warning. The vehicle was taken to the dealer where it was diagnosed brake sensor and pedal position senor had malfunctioned and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. There was a recall for this failure NHTSA campaign number: 14v252000 (electrical system , electronic stability control , exterior lighting , service brakes, hydraulic , vehicle speed control) however this vehicle's VIN was not included. The vehicle failure mileage was 42,000. Kh.