Engine And Engine Cooling Related Problems of the 2010 Chevrolet Silverado

Table 1 shows three common engine and engine cooling related problems of the 2010 Chevrolet Silverado. The number one most common problem is related to the engine and engine cooling (nine problems). The second most common problem is related to the engine head gasket failure (one problem).

Table 1. Engine And Engine Cooling related problems of Chevrolet Silverado


Recently reported Engine And Engine Cooling problems of the 2010 Chevrolet Silverado

The Engine And Engine Cooling problem

My oil pressure sending unit has been replaced twice in two months. The oil pressure will be fine when starting the engine cold then gradually as the engine warms up it drops and drops until the "low oil pressure" light comes on and the display says to stop engine.   Read details...

The Engine Head Gasket Failure problem

Submission from constituent re gm issues (full document not imaged). The consumer stated the check engine and traction control light illuminated. The #7 cylinder and head gasket were replaced. The right rear spring was broken. The vehicle was consuming excessive amounts of oil.   Read details...

The Gas Recirculation Valve (egr Valve) problem

Winter of 2014, Silverado would engage it's stabilitrack control. When this happens it slows the speed at which the truck could go if it sensed the roads may be icy. The truck would move but very slowly and it felt as if you had no control over it. Even when braking it seemed to not want to brake.   Read details...


Engine And Engine Cooling related problems in other Chevrolet Silverado model year vehicles:



Fuel Economy of Silverado Vehicles
Silverado Service Bulletins
Silverado Safety Recalls
Silverado Defect Investigations