Check Engine Light On problems of the 2019 Chevrolet Silverado 1500

Started to drive my truck this morning and it was driving very rough. Dashboard warning lights came on; service parking brake, service esc, check engine light, stability control light, parking brake on indicator. None of this was happening yesterday. It just happened this morning. This truck only has 7,100 miles on it.

After performing the latest recalls the check engine light illuminated with a p25a2 code. I did not notice any change in the vehicle handling or performance. After I took the vehicle to the dealership for service they told me that they couldn't find an error code, only the p25a2 code which is to illuminate the check engine light. I believe it was the brake system that triggered the light if I recall what the service technician told me correctly. Additionally, at idle speed, especially while turning the steering wheel the vehicle seems to lung forward at times creating the risk of a potential front end collision.

Tl- the contact own sa 2019 Chevrolet Silverado 1500. The contact stated that the transmission failed and was replaced. The contact stated that while driving the vehicle jerk, the check engine warning light illuminated. The failure recurred a third time. The vehicle was taken to jake sweeney Chevrolet service dealer, (33 w kemper rd, cincinnati, OH 45246) where a road test was completed and determined that the transmission needed to be replaced for the third time. The vehicle was not repair. The manufacturer was made aware of the failure and provided a case. The failure mileage was 11,000. Aw.

On January 22, 2020 I started the vehicle with using the mychevrolet phone app. I got into the truck and pushed the ignition button. The following three warnings appeared on the instrument panel: 1) brake system failure 62 mph top speed, 2)service trailer brake system, 3) service esc abs, brake, traction control, and check engine lights illuminated. I turned the vehicle off and turned it back on again using the ignition button and all warnings and lights cleared except the check engine remained illuminated. The vehicle was parked when all of this happened. I received an email from onstar reporting that an issue with the antilock braking system was detected. This vehicle had just been into the dealer the prior week to fix one recall associated with the battery cable, and two other recalls associated with the brakes.

Seemed as if the car would almost slip in and out gear when diving approx. 30-40 mph. I then noticed the check engine light came on and flashed engine reduction and seemed to lose some power. I took it in to the dealer, 2 days later they replaced r&r camshaft position actuator magnet intake. The next day after the truck back. I started the truck it put it in reverse and the engine stopped running but it seemed as if it the engine was still running as when you use the remote to start the truck, after the 4th try the truck stayed running but the engine reduction warning had lit up again. The truck has been back at the dealers for 6 days trying to figure out the problem.

Upon starting the truck and putting it in drive, the parking brake maintenance light, check engine light and abs light came on. It provided multiple warnings that it needed service and put the engine in �low power mode�.