Service Brakes Problems of Chevrolet Venture

Was driving forward coming up to an intersection and approaching a red light when the brakes went out . When trying to stop and push the brake down it started shaking and the brake came up and then when pushed it back down it went to the floor and the brakes were completely out. Them going out caused us to roll through the intersection causing us to get hit by a vehicle coming through the light, spinning us around and got hit more than once. Hit us on both sides of vehicle and windows were shattered out but not one air bag went off/deployed at all and the vehicle was totalled. There were 3 babies in the vehicle when the air bags did not deploy.

See all problems of the 2000 Chevrolet Venture 🔎.

Emergency brake cable is hanging loose under van due to brackets holding cable having rusted out. The rocker panel on the driver's side is badly rusted, as is the rocker panel on the passenger's side.

See all problems of the 2003 Chevrolet Venture 🔎.

The contact owns a 2005 Chevrolet Venture. The contact stated that while driving 40 mph, he attempted to slow down and the vehicle began to pull toward the right. The bearing on the braking system also began to grind. The contact stated that the bearings needed to be replaced and he repaired the vehicle himself. The failure recurred once more and the contact took the vehicle to a repair shop for repair. The failure continued to recur. The contact had not notified the manufacturer. The failure mileage was 50,000.

See all problems of the 2005 Chevrolet Venture 🔎.

The brake does not engage. Causing the car to still move when you press as hard as possible. This is going to cause and accident and kill someone. I saw enough complaints that between all them and the ones still coming in, something needs to be done.

See all problems of the 2001 Chevrolet Venture 🔎.

When the brake was applied, the pedal went all the way to the floor.

See all problems of the 2002 Chevrolet Venture 🔎.