Seven problems related to brake abs warning light have been reported for the 2012 Chrysler 200. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2012 Chrysler 200 based on all problems reported for the 2012 200.
The contact owns a 2012 Chrysler 200. The contact stated that while driving at an unknown rate of speed, the traction, brake, and abs warning lights all simultaneously illuminated on the instrument panel. The contact then took the vehicle to an independent mechanic where the vehicle was diagnosed with a defective hydraulic brake module and brake pump. The mechanic called several unknown local dealers and each dealer informed him that the part was discontinued. The manufacturer was not notified of the failure. The vehicle was not repaired. The failure mileage was approximately 149,000.
My abs light has turned on. And my abs isn't working. Also my radio also is only working intermittently.
The abs and terrain lights stay on, when car reaches 60 mph it pulls.
Takata recall, abs and traction light are on they make a funny noise when I first start the car and start driving. But after I go so far or to 25mph, my lights come on and I brake just fine. I also have a issue with my turn signals, if my headlights are off my front left turning sognal works but if my headlights are on my front left turning signal does not work.
Replaced disc breaks pads 3 times last year and 2 times this year, the rubber boot inside the break caliber melted and the rear breaks sometimes smokes, now front break pedal goes towards the flow and with clucking noise, andtbe abs break light is on while I was driving. .
The contact owns a 2012 Chrysler 200. The contact stated that while driving at 70 mph, the headlights failed without warning. The contact also stated that the traction control, the cruise control and the abs warning lights were illuminated. The contact also stated that there was a grinding noise coming from the front of the vehicle. The vehicle was not taken to be diagnosed or repaired. The manufacturer was notified of the failure. The approximate failure mileage was 112,000.
The contact owns a 2012 Chrysler 200. The contact stated that the abs warning light illuminated as the front end exhibited a loud metallic noise. The vehicle was taken to the dealer where a diagnostic was performed, which located the failure at the driver's side front wheel bearing. In addition, the abs system was faulty. The dealer disconnected the abs system. The driver's side front wheel bearing was not repaired. The contact also wanted to add that the water pump was replaced due to loud noises that were emitted while driving. The failure mileage was 17,000 and the approximate current mileage was 21,000.