Three problems related to brake loud noise have been reported for the 2013 Chrysler 200. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2013 Chrysler 200 based on all problems reported for the 2013 200.
2013 Chrysler 200. Consumer writes in regards to loud noise coming from brakes, only when backing up. The consumer also stated while driving 50 mph, the vehicle would slow down, as if it were going to stop. The dealer informed the consumer, it sounded as though it was a transmission problem.
Not long after purchasing my 2013 Chrysler 200 I noticed that every few days I had to get air in my tire. When I had my very first service I mentioned to the service dept. They looked at the tires and put air in them. Then it was the same every few days put air in tire. Well on next service it was the same old thing nothing wrong put air in tires this just keeps going on. Well when it was time to rotate tires then the problem got a little worse. Had to go from every few days to every other days at next service got the same statement nothing wrong. Now its got to the point I have to put air everyday and not just one tire but all of them. I just now got to 30,000 miles on my car. Also they said and tried to talk me into getting nitrogen put in which cost money and if your on the road and your tire goes low you can't put air in a nitrogen tire. I don't know why the tires keep loosing air but this is darn ridiculous. Also like another person reported quite some time ago my brakes make a terrible noise when backing up.
The contact owns a 2013 Chrysler 200. The contact stated that while driving approximately 5 mph, the brake pedal was depressed and a loud noise emitted continuously. The failure recurred whenever the brakes were applied. The vehicle was taken to an authorized dealer three times however, the dealer was unable to duplicate the problem. In addition, the front hood was misaligned and repaired. The manufacturer was notified of the problem. The approximate failure mileage was 900. The VIN was unavailable.