Frame And Members problems of the 1997 Chrysler Concorde

Two problems related to frame and members have been reported for the 1997 Chrysler Concorde. The most recently reported issues are listed below.

1 Frame And Members problem

Failure Date: 10/01/2007

My car started making a clunking noise, and I checked out the problem and found the engine cradle bushing were junk. The car only had 62000 miles on it. This could of caused a very bad accident if the cradle had broken. The car was lifted off the ground and there was about a 2 iinch gap between the frame and cradle where the bushing are worn out. I current don't drive this car do to this issue.

2 Frame And Members problem

Failure Date: 07/12/2001

Had taken vehicle to dealer for rear alignment, but could not be performed due to corrosion anddeterioration on subframe mounts. Consumer talked to manufacturer, and he was unable to take care of this situation.

Other Structure related problems of the 1997 Chrysler Concorde

Frame And Members problems	2
Structure problems	2
Hood problems	2

Switch Make:

Switch Model:

✿ Fuel Economy of Concorde Vehicles

☘ Concorde Service Bulletins

⚑ Concorde Safety Recalls

☤ Concorde Defect Investigations