general problems of the 1999 Chrysler Sebring

Three problems related to structure have been reported for the 1999 Chrysler Sebring. The most recently reported issues are listed below.

1 Structure problem

Failure Date: 06/07/2010

I have a 1999 Chrysler Sebring which has had the ball joint come out of both sides of the vehicle of the front 2 wheels about 6 months apart. This has caused damage to my vehicle which I have repaired. I am very concerned about my safety and the safety of my family because this last time I was about a mile away from getting on the highway, which could have been deadly. I feel that this is a safety issue and wonder about recalls and if I should be reimbursed. The tow to my home was $106, the tow to the mechanic was $65 and the mechanic bill was $303. This is just the drivers side. This happened on the passenger side as well and I feel I should be reimbursed for both. Documents of these charges can definitely be provided if needed. I am concerned about this happening again, not just my own car but anyone else that may be driving one of these vehicles. Please let me know either way. Thank you.

2 Structure problem

Failure Date: 03/25/2004

While opening the driver 's door, the handle fell off. Two weeks later the passenger side handle fell off as well. The driver pick up the handle and drove to the dealer. The mechanic replaced both handles due to worn parts. Please provide any additional information.

3 Structure problem

Front end too low. Yh.


Other Structure related problems of the 1999 Chrysler Sebring



Fuel Economy of Sebring Vehicles
Sebring Service Bulletins
Sebring Safety Recalls
Sebring Defect Investigations