Two problems related to crankshaft position sensor have been reported for the 2008 Chrysler Sebring. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2008 Chrysler Sebring based on all problems reported for the 2008 Sebring.
Takata recall, the tire pressure light has been on for some time now and as recently as last month my service engine light came on requiring me to change the crankshaft position sensor. Last week my stereo was shorted out and my cruise control no longer works and only my high beams are working. Today my car would not start and I took it to dealership because when I tried to start it the dash flashed as if it shorted out and come to find out my battery was dead drained for some reason. There has also been a couple occasions when my convertible top got stuck in open position and would not go down. I had to wait about 5 minutes before restarting car to get top to close all the way down. The car was parked when opening and closing top. The tire pressure icon is still showing on dash board.
While driving the engine light came on, loss speed occurred, car felt like in was going to dye on the freeway. No excellaration power. Engine light flashing, throttle light flashing in red. Car has no pick up. I have called Chrysler and was told no recall. I had it checked at local auto shop and code was p0035. Crank shaft sensor. Many customers have had this issue and no one not even Chrysler can figure out the problem.