Chrysler Town & Country owners have reported 16 problems related to child seat (under the child seat category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chrysler Town & Country based on all problems reported for the Town & Country.
The contact owns a graco nautilus safety seat, model number 1878678jj, and manufactured July 15, 2014. The child seat was being utilized in a 2000 Chrysler town and country by the latch system. The contact stated that while the seat was secured in the vehicle, the seat began to move liberally and caused the latches to become loose without much effort. The contact was concerned with how easily the latches became unsecured. The manufacturer was not contacted. (related vehicle information: model year=2000, make=Chrysler, model=town and country).
See
all problems of the 2000 Chrysler Town & Country
🔎.
Our sunshine kids radian xtsl is not holding at the point of superlatch as it should. After confirming we have a tight install, just a touch, knock, nick, anything to the release tab will loosen the strap to the point of the seat tipping. Several times I have gone to take my son out of his seat and his seat is completely loose (even though I check his seat weekly and know it is tightly installed). (related vehicle information: model year=2008, make=town and country, model=Chrysler).
See
all problems of the 2008 Chrysler Town & Country
🔎.
The contact owns a sunshine kids radian xtsl child restraint, manufactured October 1, 2009. The model number was unknown. The child restrain was secured in a 2009 Chrysler town and country. The contact stated that the latch straps had become loose while the vehicle was being driven. The manufacturer was made aware of the failure yet the child seat was neither repaired nor replaced. The contact stated that the child seat was no longer being used. The failure mileage and VIN were unavailable.
See
all problems of the 2009 Chrysler Town & Country
🔎.
The portable travel child seat is not able to be installed in the vehicle properly. Several technicians tried unsuccessfully to install child seat in vehicle.
See
all problems of the 2002 Chrysler Town & Country
🔎.
Inspection by a child protection system technician, revealed the shoulder harness on the intergrated child safety seat of 2002 Chrysler t/c would not retract. This is same problem occured on the 2nd seat child seat in van. This poses a serious hazard to the child because the child safety seat may not function properly in a crash.
The seat was not locked and when the consumer applied the brakes suddenly, the child safety seat moved and the baby car seat lunged forward. The baby bruised his/her face. It must have symbol to let you know seat is locked into placed.
See
all problems of the 2001 Chrysler Town & Country
🔎.
The vehicle childseat came with the vehicle isn't stable. The childseat lock in the pelvis area below. But there is nothing holding the chest upper area. Nlm.
See
all problems of the 1996 Chrysler Town & Country
🔎.
Intergrated child seat located behind drivers seat is difficlult to open when latch becomes contaminated from child eating. Seat has never been used. There was recall 98v185000 on this problem, but consumer's vehicle was not included due to VIN.
See
all problems of the 1997 Chrysler Town & Country
🔎.
Built in child seat has a flip down front which was not properly locked. Child was in built in seat when it flipped forward and then backwards hitting child in face. Child lost a couple of front teeth.
Child got out of integrated child seat.
Had placed child in buil- in chid seat when getting child out, latch would not release. Would pull on "t-shield" & it got tighter. Started rising toward child's throat. Tried releasing from bottom, did not work; had to literally drag child from seat.
Problem with child safety seat.
Vehicle shuts down and control panel goes blank while vehicle is in motion. Vehicle front end shakes. Child was stuck in built-in safety seat because belt would not release.
Integrated child safety seat harness/straps continued to tighten around child and would not loosen.
At least ten times integrated child safety seat belts froze up, not allowing child to exit. The belts will tighten when further attempting to release. The release button is extremely hard to get to. Please describe details.
Integrated child seat locks fail locking children in. Please describe details. Tt.
Problem Category | Number of Problems |
---|---|
Child Seat problems | |
Infant Child Seat Harness Buckle problems | |
Child Seat Material/padding problems | |
Child Seat Latch Connector problems | |
Child Seat Positioning Clip problems | |
Child Seat Tether Strap problems | |
Infant Child Seat Handle problems |