Two problems related to steering rack and pinion have been reported for the 2007 Dodge Caliber. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2007 Dodge Caliber based on all problems reported for the 2007 Caliber.
The contact owns a 2007 Dodge Caliber. While driving 30 mph, a noise was heard under the rear and front of the vehicle. There were no warning indicators illuminated. The vehicle was taken to an independent mechanic who diagnosed that there was rust on the subframe, which damaged the rack and pinion. The contact was informed that the vehicle was unsafe to drive. The vehicle was not repaired. The manufacturer was not made aware of the issue. The failure mileage was approximately 106,070.
The contact owns a 2007 Dodge Caliber. The vehicle was taken to an authorized dealer for routine maintenance when the technician detected that the front brake rotors exhibited severe rust and corrosion. The shims, front brakes and rotors were replaced. In addition, the inner tie rods loosened from the steering rack and the front control arm bushing separated. The vehicle had not been repaired. The manufacturer was not notified of the defect. The failure mileage was 23,167. Updated 06/05/lj the consumer stated that Chrysler has since repaired the vehicle. Updated 06/06/12.