Brake Grinding Noise Problems of Dodge Caliber

I've had the arm bar and ball joint replaced twice in a year's time, which causes a grinding noise. I've had the brakes replaced three times along with rattle clips, in the last year, with no prevail in changing the noise nor high speed-braking oscillating. A caliper has also been replaced. While sitting at stop lights, the car unpredictably stalls-- I've tried to reproduce the setting to have the issue happen when a technician tests it, but it appears to happen unpredictably. The car has leaked from some entry point to cause the floor boards to be wet, and in the last year, the sun roof seems to be leaking as I have water pouring onto me from the front dome lightt. The water is causing mold, which is not beneficial to the family I drive with. Based on the NHTSA site and the thousands of youtube videos, these are pretty wildly known issues by Dodge, despite the lack of complaints on these sites.

See all problems of the 2010 Dodge Caliber 🔎.

The contact owns a 2008 Dodge Caliber. The contact stated that the vehicle swerved and made a clicking sound while driving. The vehicle was taken to the dealer where it was diagnosed that the front ball joint and the lower control arm failed. The vehicle was repaired but the failure recurred. The vehicle was taken back to the dealer where an alignment was performed but failed to correct the failure. The contact also stated that the brake system failed. The brake emitted a metal grinding noise when the brake pedal was engaged. The dealer inspected the brake system and found corrosion on the brake lines the corrosion was removed from the brake lines however, the failure was not corrected. The manufacturer was notified of the failure. The failure mileage was 133,833.

See all problems of the 2008 Dodge Caliber 🔎.