Two problems related to brake sensor have been reported for the 2017 Dodge Journey. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2017 Dodge Journey based on all problems reported for the 2017 Journey.
Tl the contact owns a 2017 Dodge Journey. While driving 30 mph, the steering seized without warning. The brake pedal was depressed, but the vehicle failed to respond and stalled. The contact was able to restart the vehicle after several attempts. The vehicle was taken to earnhardt Chrysler Dodge Jeep ram (located at 1521 e drivers way, gilbert, az 85297, (480) 926-4000) where it was diagnosed that the map sensor needed to be replaced. The vehicle was repaired; however, the failure recurred several times. The manufacturer was notified. The approximate failure mileage was 41,000.
This is a follow-up to 11244334 and 11243797. For background, the 2017 Journey began stalling intermittently and not throwing a code (starting at about 23,500 miles). The stalling occurred during all driving conditions and speeds. The dealership could not reproduce the event and told me to drive until it throws a code. After 6,000 miles and hundreds of stalls the vehicle finally threw a code, (29,500 miles, p0335 crankshaft position sensor). The sensor replaced, connector did not fit sensor well so it was replaced (subject of complaint 11244334). Thought it was fixed, and three days later, it stalled again on the highway. Only this time the traction light came on and brakes did not work intermittently. Back at the dealership, the technician in his frustration and opened the wiring harness. What he found about 8 inches from the connector was "crank shaft position wires cut and twisted together. . . " the service advisor asked who else was in there. I bought the vehicle new at the dealership and they have done all work and maintenance meaning this issue was in production.