Speed Control Linkage Problems of Dodge Ram 2500

Dodge Ram 2500 owners have reported 10 problems related to speed control linkage (under the vehicle speed control category). The most recently reported issues are listed below.

1 Speed Control Linkage problem of the 1998 Dodge Ram 2500

Failure Date: 09/07/2014

Driving at highway speed the cruise control would not disengage via the brake or by hitting off on the steering wheel. If I put the clutch in the engine was idling at 2300 rpms. The throttle was stuck on and I could not slow down. . . I turned the engine off and turning it back on again the problem was not reset. My clutch and breaks got a little burnt up making it home that night. . . As the problem happened when I was in the middle of nowhere. One I made it home I turned the engine off and manually jiggled the throttle linkages on the side of the injection pump. Restarted the vehicle and the the problem was reset until cruise control was used again. . . . This was very dangerous to have the throttle sticking at such high speed. . . So I looked into safety recalls #b15 thinking great my truck is covered. . . Only to find out that recall was already performed. Also the fuel heater recall was performed and it so happens in the last 4 moth hhave to do the furlel heater delete because the wiring and plastic piece was all burnt up. Looks like these trucks are having a second round of the same or similar safety recall issues.

See all problems of the 1998 Dodge Ram 2500 🔎.

2 Speed Control Linkage problem of the 1998 Dodge Ram 2500

Failure Date: 10/29/2002

While accelerating vehicles throttle pedal goes to the floor. Consumer has to cut off engine in order to release throttle cause is unknown. Please provide any further information. Ts.

3 Speed Control Linkage problem of the 1998 Dodge Ram 2500

Failure Date: 08/29/2002

Nhtsa recall 02v161000, throttle linkage; norton motors in California will not accept appointment from this consumer 2 to 3 weeks from today. Owner didn't purchase vehicle in California but in florida where they resided. They didn't say that refusal was because of not having the parts available. Please describe details.

4 Speed Control Linkage problem of the 1996 Dodge Ram 2500

Failure Date: 07/13/2002

Throttle cable hung up at 70 mph and could have caused accident!.

See all problems of the 1996 Dodge Ram 2500 🔎.

5 Speed Control Linkage problem of the 1996 Dodge Ram 2500

Failure Date: 06/13/2001

Contacted Chrysler@1 800 424 9393 and advised them there was manufacturer's 970 for this throttle cable. They advised me there was no recall on this cable ,and referred me to the warranty dept at which they advised me that it was out of warranty . Please help thanks.

6 Speed Control Linkage problem of the 1997 Dodge Ram 2500

Failure Date: 04/01/2001

Throttle linkage bar has split down the middle. Dealer has been contacted. Consumers vehicle was not part of manufacturer's recall. Consumer stated the solid steel linkage cracked int he middle, no acceleration possible.

See all problems of the 1997 Dodge Ram 2500 🔎.

7 Speed Control Linkage problem of the 1996 Dodge Ram 2500

Failure Date: 04/15/2000

Consumer stepped on throttle and it became stuck, consumer had to shut off ignition in order to stop car. The strands on cable became unraveled at cable housing, causing throttle to stick wide open. Throttle cable and linkage were replaced by Dodge dealer at my expense. New cable and linkage are of a different/improved design.

8 Speed Control Linkage problem of the 1996 Dodge Ram 2500

Failure Date: 10/06/1998

Accelerator cable broke under normal use.

9 Speed Control Linkage problem of the 1997 Dodge Ram 2500

Truck surges at speeds between 40-65 mph. Throttle linkage failure.

10 Speed Control Linkage problem of the 1996 Dodge Ram 2500

Throttle cable was frayed to the point that only one strand was remaining. Nlm.



Ram 2500 Service Bulletins
Ram 2500 Safety Recalls
Ram 2500 Defect Investigations