Seats Problems of Ford Contour

The contact was sitting in the driver seat while the vehicle was parked. The driver seat suddenly fell backwards and the hinge broke. The seat felt lose prior to the failure, but had not been inspected. After inspection the dealership said the breakage was due to fatigue of the seat frame. The entire seat was replaced. Updated 2/21/2006 -.

See all problems of the 1998 Ford Contour 🔎.

Back of driver's seat on my 1998 Ford Contour VIN [xxx] broke off evening of 05/05/05 as I was getting out of car. Car has never been in an accident. I feel this is a result of defective design and/or materials, and that Ford should replace free. However, when I contacted their customer relationship center the representative said Ford would not. Information redacted pursuant to the freedom of information act (foia), 5 u. S. C. 552(b)(6).

I own a 1998 Ford Contour se, recently on 10-13-04 I was driving and the back of my seat gave out, causing me to loose temporary control but avoid an accident. Upon closer inspection of the seat, I found the entire right side of the seat was disconnected. The metal had sheared in half, I couldn''t understand how that had happened. The bolt was still intact, the metal had just sheared into top and bottom causing the seat to fall immediately backwards. I sent emails to Ford motor corporation and the dealer I purchased it from brand new, seeing if something could be done to help. So far I have not heard any response and my car is a safety hazard on wheels, with no usable seat belt and no support to drive. I am a recent college grad and can't afford to not work, so I must still drive it everyday.

Consumer states when pulling off or braking the passenger seat moves backwards and forwards, causing the passenger to jerk. Please provide any additional information. Ts.

See all problems of the 1997 Ford Contour 🔎.

I accelerated leaving a stop light and the driver seat back collapsed. Upon further review a metal bracket snapped clean in half. I have looked this up on the internet and it apears to be a common occurance with the Ford Contour. However, Ford seems unwilling to do anything about itand the part is not covered by warranty. Mr.

While driving driver's side seat came loose and fell into the floor of vehicle, almost caused an accident, consumer stated the frame of the seat was crtacked. The recall (99b23) on the water pump expired because the dealer was booked up several times and the consumer was unable to leave the vehicle at the dealer.

Driver's side seat,backrest,right side,internal steel framework,snapped completely through,causing me to lose control of vehicle and almost being involved in a traffic collision.

This pretains to the driver's seat. The reinforcing bar attached to the rear, underside of the seat pan has snapped. This bar connects the seat pan bottom to the seat tracks. The broken bar is allowing the seat to move from side to side. The seat and track assembly appears to be loose.

Replacement seat track starting to fail, feeling a "rocking" in the driver side seat.

See all problems of the 2000 Ford Contour 🔎.

Driver's seat is loose, affecting driver control of car. Additionally, loose seat also presents safety hazard in event of a crash. Two dealers acknowledge problem but both were unwilling to fix. They justified their refusal to fix by suggesting the need for a recall since "all Contours have the same problem". One dealer even used the term defect to describe the problem.

Was driving when driver's seat collapsed backwards without warning. This caused driver to contact visibility with road. Lost control of vehicle. Vehicle was declared totaled. Contacted manufacturer & informed someone will get in touch.

Welding snapped at seat frame causing drivers seat to fall backwards. Nlm.

Loose seat track, I fear that it may fail during cornering and cause a crash.

Driver's seat moves back unexpectedly due to broken pivots which may cause loss of vehicle control. Dealer fixed driver's and passenger's seats on numerous occasions, but could not determine the cause of the problem. Please provide further information.

No summary mentione dfor this vehicle.

Consumer states that the drivers seat was loose due to faulty track, the seat belt was also improperly installed.

The seat track of the Contour allows the seat to rock back and forth considerably, especially during braking and accelerating. I have never experienced a seat that rocked back and forth like this. So I brought it to the attention of the dealer. The dealer checked for problems and foud none. The loose seat persists and when I asked the dealer about it again I was told that it is 'normal' for the the seat to seem loose and rock back and forth on this car. This doesnt seem right to me, it is very disconcerting especially since over time the seat rocks more and more. I am concerned that eventually it will come loose completely.

Seat track problem: seat track "pops" and moves during cornering, which directly affects driver's position and steering; can cause unintentional swerving while cornering; seat track has been replaced 3 times and each replacement has failed. Ford has not.

See all problems of the 1996 Ford Contour 🔎.

The vehicle was rearended by another vehicle and both the driver's and the passenger's seats collapsed. Dealer has not seen the vehicle.

Driver's side and passenger's side seat track and anchor system is rusting out. Dealer has not been contacted .

Driver's seat stays loose and will rock back and forth. Consumer has asked dealer to replace seat, but dealer will not replace it.

Problems started at 119miles, dealers either don't confirm problem or say it's normal for this car. Multiple repair attempts at 4 dealers. Severe vibration and pull at highway speeds are the tires (confired with my winter tires-no problem), klunking from front end when going over bumps, all dash warning lights come on during winter at idle-go out after restart or engine acceleration, front seats wobble side to side-dealer says normal for car-wan't present when new, pulsing front end shimmy on highway-not tire related-possible cv shaft issue-dealers stated npf, engine spark knocks under light loads-no change with different gas grades or brands-dealers says npf, headlamps go dim at idle-dealers says normal-not present when new, poor low beam visibility from headlamps, aluminum wheels are too porous-lose abnormal air amounts-dealer says npf. Most of these have been since new or started within 1st year of new- no dealers has yet "confirmed" problems when they are readily apparent to others. In shop for over 3 months total since new. (tiresize: p205/60r15)( dot number: tire size: p205/60r15 ).

See all problems of the 1999 Ford Contour 🔎.