Brake Electric Antilock problems of the 1999 Ford Crown Victoria

Five problems related to brake electric antilock have been reported for the 1999 Ford Crown Victoria. The most recently reported issues are listed below.

1 Brake Electric Antilock problem

Failure Date: 12/10/2000

Continous squealing and grinding brakes 4 attempts to correct, no relief.

2 Brake Electric Antilock problem

Failure Date: 01/01/2000

When applying brakes on a damp road vehicle pulls to the left. Manufacturer states that this is a normal condition. Vehicle will be checked by dealership. Please provide any further information.

3 Brake Electric Antilock problem

Failure Date: 05/02/1999

Brakes went bad, they were rubbing metal to metal and making a winding noise. Also, there was a loud clunking noise because the lower control arm went bad, and they replaced it. When consumer applies brakes vehicle pulls to the left.

4 Brake Electric Antilock problem

Experiencing chronic brake fade / low brake pedal / vibration coming off freeway/ dealership service claims to have checked brake system / says this is normal / concerned.

5 Brake Electric Antilock problem

While driving vehicle 35-40mph in wet weather & applying brakes vehicle would pull to the right. Contacted dealership & was informed by mechanic the pulling problem was not correctable.


Other Service Brakes related problems of the 1999 Ford Crown Victoria



Safety Ratings of Crown Victoria Cars
Fuel Economy of Crown Victoria Vehicles
Crown Victoria Service Bulletins
Crown Victoria Safety Recalls
Crown Victoria Defect Investigations