general problems of the 1999 Ford Crown Victoria

My 99 Ford Crown Victoria lx has front end issues. I have had to replace the ball joints about 4 times every 2 to 3 months because the front end keeps dropping. I'm not sure if you guys know about this but I've spoken with our local Ford mechanic and a few friends who have Crown Victoria's as well and said that it has been a big issue with them along with the electrical components for the turn signals.

The turn single commilm is messing up. The wipers will not work.

Defective intake manifold is was made of a cheap plastic. .

My name is david winebrenner and my Ford Crown Victoria has a problem with the rear axle assembly the c-clip keeps falling off the axle shaft and I think this should be a recall I'm not sure how many other people experienced this problem but I am and the rear end is too expiencive to repair and I think this should be admitted to Ford because the axle shaft is faulty and the differential 3:55 is a bad concept on my car I don't speed or beat my car down or dog it out I drive the speed limit and use the car as supposed to and the other problem is the car has random misfires as well the problem I insist of complaining of can cause an accident or worse and I feel Ford should recall the car for this major problem please contact me if you can have something done about these problems.

Consumer experienced problems with the floor mat on the driver's side. Ts. The floor mat moved around and became stuck to the hooks which were embedded in the floor and were flat from normal wear. Consumer was unable to hook the floor mat on the apparatus, therefore the floor mat slid under the accelerator. Scc.