Brake Sensor problems of the 2011 Ford Escape

Two problems related to brake sensor have been reported for the 2011 Ford Escape. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2011 Ford Escape based on all problems reported for the 2011 Escape.

1 Brake Sensor problem

Failure Date: 11/01/2020

The instrument cluster started by flashing all lights to staying on. Then the speed controls, speedometer, rpm gauge, and heat sensor would not work. On top of all this. The brakes began to make a clicking noise when this issue would happen and the brakes would act rough. No mechanic could figure out the problem until it was to late. This needs to be better known and better managed.

2 Brake Sensor problem

Failure Date: 01/28/2018

Tl the contact owns a 2011 Ford Escape. While the contact's son was driving approximately 35 mph, the steering wheel seized and the abs and stability warning indicators illuminated. The vehicle was driven home. The following day, the vehicle was taken to andy shaw Ford (1231 e main st, sylva, nc 28779, (828) 586-0900) where it was diagnosed that the steering sensor and column needed replacement. The vehicle was repaired. The manufacturer was made aware of the failure and a case was opened. The failure mileage was approximately 41,349.


Other Service Brakes related problems of the 2011 Ford Escape



Safety Ratings of Escape Cars
Fuel Economy of Escape Vehicles
Escape Service Bulletins
Escape Safety Recalls
Escape Defect Investigations