Engine Belts And Pulleys problems of the 2006 Ford Escape Hybrid

One problem related to engine belts and pulleys has been reported for the 2006 Ford Escape Hybrid. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2006 Ford Escape Hybrid based on all problems reported for the 2006 Escape Hybrid.

1 Engine Belts And Pulleys problem

Failure Date: 03/04/2015

I was driving on the 495 beltway (approx 55mph) in the right lane when suddenly my car lost power and the fail safe message appeared saying stop the car immediately. Fortunately, I was able to take a nearby exit off the beltway without injuring myself or someone behind me and causing a multiple car collision. A red triangle icon appeared on the dashboard including other lights and messages since the car had no power. I did have the car heater on due to winter temperatures. I immediately turned the car off and rested it and did not put my heat back on suspecting the electronic motor coolant pump as the problem after recently reading a nyt article. The car started about 10 minutes later. I made an appt w my Ford dealer to inspect the car for this problem. I had a similar problem last summer and was told by Ford that my VIN didn't have any recalls. I had the a/c on that day. Unfortunately, the recall for throttles only applies to Ford non-hybrid cars. There has only been a service bulletin to Ford mechanics and no recall for the electronics motor coolant pump. This incident scared me and I feel my car is unsafe to drive esp on interstate highways at high rates of speed until this problem is resolved.




Fuel Economy of Escape Hybrid Vehicles
Escape Hybrid Service Bulletins
Escape Hybrid Safety Recalls
Escape Hybrid Defect Investigations