Three problems related to brake hoses, lines/piping, and fittings have been reported for the 1996 Ford F-350. The most recently reported issues are listed below.
The contact complained about a brake problem. The brake fluid caused corrosion on the brake fittings. On August 7, 2003 the front brakes failed while the vehicle was going up hill. The Ford dealer replaced the tubing and fittings. On may 24, 2004 the rear brakes failed while he in a parking lot. Again the Ford dealer replaced the tubing and fittings. On November 1, 2005 the master cylinder experienced corrosion at the brake fittings, causing the brakes to fail. There was brake fluid pouring out of the front driver side wheel. Another dealership drained the brake system and replaced the line. The problem has not recurred. Updated 11/29/2004 -.
Stepped on brake to release the parking brake and the brake peddle went to the floor, causing me to hit a post. On investigation I found the brake line to the rear wheels rotted in the middle. All other lines in the area are like new. I have owned much older vehicles without having brake line problems. I believe the material in these lines are quite inferior and dangerous for a vehicle. I had just been towing my fifth-wheel trailer the day before.
Drove this truck over 1000 miles this trip and parked it for 2 weeks. Then to travel a short distance brake pedal went to the floor first time to apply brakes. Found brake fluid running off frame, and had mechanic inspect for problem. Found brake line that goes to the rear brakes was rotted the full length front to rear. All other lines(fuel,etc) in the same area were in good condition. New line was installed. .