Steering Wheel Vibrate Problems of Ford Fiesta

The contact owns a 2014 Ford Fiesta. The contact stated that the hard edge on the trim of the steering wheel would constantly cut the contact¿s hand. Also, the contact mentioned that the steering wheel would vibrate and a buzzing noise emitted from the steering column. In addition, the vehicle failed to shift when in reverse, the vehicle would grind and independently shift in to neutral. The traction control and hill assist also intermittently illuminate while driving. The vehicle was taken to two different dealer, on 5 separate occasions. The technician diagnosed that the power steering module, sensors, nvh tape, steering wheel, steering module, reprogrammed main computer, and air bags were all replaced. A Ford engineer was contacted to diagnose the cause of all these failures. However, all failures except the traction control and hill assist light were not rectified. The vehicle was not repaired. The manufacturer was made aware of the failures. The failure mileage was 2,420.

See all problems of the 2014 Ford Fiesta 🔎.

The contact owns a 2012 Ford Fiesta. The contact was driving approximately 35 mph when the vehicle began to shake abnormally. The steering wheel vibrated and would steer the vehicle into the opposite direction upon turning. The steering wheel also seized for a brief moment. There was an illumination of the traction control on and traction control off warning indicators. The failure recurred four times. The vehicle was taken to an authorized dealer for diagnosis where the technician detected a trouble code within the steering angle sensor module however, they were unable to determine the cause of failure. The vehicle was not repaired. The manufacturer was notified of the problem. The approximate failure mileage was 6,000.

See all problems of the 2012 Ford Fiesta 🔎.