Camshaft Position Sensor Problems of Ford Freestar

2004 Ford Freestar ses I changed the rear brakes on 1/20/2013 noticed the left rear wheel was rusting out. Today 2/24/2013 went to install a car sear & noticed the bench seat in the back was rocking slightly. The anchor point on the left rear is rusted out and moving. Upon inspection I noticed that I can see down to the ground where the anchor point has rusted out. I have had to replace numerous parts on this van over the last two years. To date I have replaced: 3 ignition coils, (this is the main problem whenever heavy rain or snow has happened and I start to throw misfire codes), 3 camshaft position sensors, 2 driver side window controls & motors, (the window doesn't want to work half the time so we leave it cracked open with the rain guards), an egr valve, and a clockspring. I have never had so many problems with this vehicle in such a short amount of time.

See all problems of the 2004 Ford Freestar 🔎.

This information is a collection of incidents that ultimately fit together. I have notice that the floor board of my van was wet. Since I have 3 kids I just shrugged it off. This past week I notice the floor mats weren't wet only the carpet beneath it was soaked. My kids don't spill just under the mats. The water must be entering from the outside in. The van was acting weird on and off -no check engine light until it started happen more frequently. June 2012, I got the p1340 code that the camshaft position sensor had gone bad, I replaced it, went out again, I was told it could have been a faulty part, changed it again, went out again, decided this is beyond me. I took it to the dealership and they "fixed" the camshaft position sensor and another part that was causing the camshaft position sensor not to work. ($900) it broke again because the part they put in was defective. They replaced the defective part and the check engine light came back on again. After they had the car for 2 weeks they found another small problem. ($130) I insisted at the time that they didn't make the proper repairs. They assured me that it all still needed to be done. (caught some double talk) I experienced a few more issues with the van losing power. (July,September, October -check engine light did not turn on. ) I:n December the car turned off and I was only able to get about 25ft per restart and the light came on. I've noticed other features not working properly or working intermittently. (power locks, power windows, radio, power doors, key remote . . . ) I have learned that other 2005 Freestar owners have experienced similar incidents caused by water leaking into the car through the windshield wiper blades and running down the wire harness causing multiple parts to short out from time to time. Please look into this. I have 3 children and no more money for "let's try this repairs".

See all problems of the 2005 Ford Freestar 🔎.

2005 Ford Freestar pcm problems. Symptoms include intermittent incidences including vehicle's failure to start, running rough, improperly accelerating, refusing to move forward/backward, and other random problems. The fuel system components/camshaft sensor/etc, as well as the transmission have been replaced on the vehicle, but all of these issues still exist. Codes do not show up on mechanic's diagnostic computers unless the car is actively having the problem, which seems to rarely happen. Mechanics, including the local Ford dealership, has not been able to confirm the problem with the pcm; however, our mechanic did find water in the computer module. He dried it out and resealed it, in hopes of resolving the issues we were having. The problems have continued though and despite lack of codes, all indications are that the computer is no longer good. Another problem is the fact that getting a replacement pcm is nearly impossible. The demand for Freestar reconditioned computers is so high that we've not been able to find one to replace the bad unit in the van. (apparently, new pcm's are not available at all. ) after seeing the massive number of on-line complaints which are so similar to ours, I cannot believe that Ford shut the case regarding the computer problem. If the diagnosis of failed pcm's is almost impossible to achieve, Ford simply chooses to ignore the obvious. (read all of the complaints on NHTSA. Dot. Gov. ) poor placement of the pcm on the back of the vehicle wall has allowed water to run off of the windshield into the unit, but Ford will not take ownership in this problem. How many people have to risk having a wreck and possibly dying due to water-damaged components? it is unfortunate and unnecessary. One last question. . . Is it possible that the transmission problems (currently on recall) be related to the water-damaged pcm's?.