Automatic Transmission Control Module problems of the 2011 Ford Fusion

Two problems related to automatic transmission control module have been reported for the 2011 Ford Fusion. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2011 Ford Fusion based on all problems reported for the 2011 Fusion.

1 Automatic Transmission Control Module problem

Failure Date: 11/04/2024

The contact owns a 2011 Ford Fusion. The contact stated while driving at an undisclosed speed, the contact noticed that the check engine warning light illuminated. The vehicle was taken to an independent mechanic where it was diagnosed that the powertrain control module failed and needed to be replaced. The vehicle was not repaired. The vehicle was taken to the dealer where it was not diagnosed or repaired. The manufacturer was made aware of the issue and referred the contact to the nhsta hotline for assistance. The approximate failure mileage was 142,000.

2 Automatic Transmission Control Module problem

Failure Date: 06/28/2011

I was traveling about 35 to 40mph when the car starting acting up. Anytime I had to slow down and then speed up the rpm would not shift, when it did shift it would jerk the car forward. I also have been having an issue where I would step on the gas and it would act as if it was in neutral. This continues to happen and I fear that one of these times I will be in an accident with my kids in the car. These are all transmission issues, I have brought it in twice now first time they did the TSB which was to reset the pcm and my ac wasn't and still is not working. Resetting the pcm did not work so now back in the shop it sits. This car is only 4 months old and already has safety issues being the transmission. There needs to be a recall before there are deaths.




Safety Ratings of Fusion Cars
Fuel Economy of Fusion Vehicles
Fusion Service Bulletins
Fusion Safety Recalls
Fusion Defect Investigations