Brake Light On problems of the 2012 Ford Fusion

Five problems related to brake light on have been reported for the 2012 Ford Fusion. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2012 Ford Fusion based on all problems reported for the 2012 Fusion.

1 Brake Light On problem

Failure Date: 04/29/2020

Brakes failed stopping suddenly at 70 mph nearly hitting a row of cars ahead of me pedal went to the floor increasing stopping distance probably 400 percent with very weal brakes. Brake light and abs inop light illuminated. Was able to drive car home slowly using hybrid electric motor brakes. Repair shop said brake control modual has failed this is a low milleage car unacceptable could get someone killed.

2 Brake Light On problem

Failure Date: 11/14/2019

Abs warning light and low brake fluid light on. The lines and master cylinder were replaced and the brakes are in worse condition. Loose and poor response when moving and needing to stop. ## #vpic# 1 - check digit (9th position) does not calculate properly #vpic#.

3 Brake Light On problem

Failure Date: 08/19/2019

While exiting from my condo parking garage, when applying the brake, brake lights came on and there was brake failure.

4 Brake Light On problem

Failure Date: 03/28/2019

While in motion on a city street, the abs light, the red brake light, and the traction control light illuminated on the instrument panel. Brake pedal engagement requires more travel to engage the brakes. The vehicle was taken to a Lincoln dealership for repair. The dealer noted that the abs module failed. After a close inspection, it was determined that the abs module had failed due to brake fluid contamination. The abs module was replaced, but I'm concerned more with the apparent cause, which appears to be the degradation of the abs hydraulic control unit (hcu), where the abs module attaches to. The abs module should have zero fluid contamination. It would seem that the replacement abs module will fail from the fluid ingress contamination again. Please review attached photos and receipt. Thank you.

5 Brake Light On problem

Failure Date: 11/25/2014

The contact owns 2012 Ford Fusion hybrid. The contact states that while driving approximately 30 mph, the brakes failed. The brake light illuminated after the brakes were applied. The vehicle was towed to an independent mechanic, who diagnosed a faulty wiring of the anti-theft system. The vehicle was repaired and the manufacturer was made aware of the failure. The approximate failure mileage was 57,000.




Safety Ratings of Fusion Cars
Fuel Economy of Fusion Vehicles
Fusion Service Bulletins
Fusion Safety Recalls
Fusion Defect Investigations