Two problems related to brake sensor have been reported for the 2012 Ford Fusion. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2012 Ford Fusion based on all problems reported for the 2012 Fusion.
Tl-the contact owns a 2012 Ford Fusion. The contact stated that while driving approximately 25 mph, a grinding noise started emerging from the rear passenger side of the vehicle. The abs, traction control, service advance trac and tire pressure sensor illuminated. The vehicle was not taken to a dealer or an independent mechanic for a diagnostic. The calipers and brake pads were replaced by the contact. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 180,000. Bp.
Tl the contact owns a 2012 Ford Fusion. While accelerating from a traffic light, there was a grinding noise coming from the rear brakes. The vehicle was taken to an independent mechanic to be diagnosed. The contact was informed that the rotors and brake pads needed to be replaced. The contact was informed that there was metal-to-metal contact between the brake pads and the rotors. The contact was concerned that the brake warning sensor failed to notify that the brakes needed to be replaced. The vehicle was repaired. A dealer was not contacted. The manufacturer was notified of the failure. The approximate failure mileage was 40,000. The VIN was not available.