Four problems related to clutch have been reported for the 2000 Ford Mustang. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2000 Ford Mustang based on all problems reported for the 2000 Mustang.
Vehicle has 24000 miles on it. At approx. 12000 miles the clutch lost travel distance, and could not be adjusted using the manual adjustment procedure. Clutch froze one morning after a very cold sub-zero night. Upon starting vehicle with clutch partially engaged, clutch burned. Then fell out of 4th gear while traveling at 40 mph. Dealer claims it is a wear item and bad driving resulted in pressure plates being unusually worn, a problem with the linkage was also noted but not assessed as contributing to the worn plates. Customer contends the linkage failed and caused continuous rubbing of pressure plates inside transmission ultimately leading to failure, and should be addressed by manufacturer. Premature wear of the plates is most likely linked to the failure in the linkage and the failure of the self adjusting clutch to in effect, self adjust when the pedal is pulled up and pushed down as recommended in the manual. Suspect this may also be a problem with the parts original to vehicle. Ts.
There is alot of hissing, grinding and whinning noises coming form the transmission (2 have been replaced), clutch assembly and driveline (driveshaft) area, dealer has attempted repair 4 times but has been unsuccessful. Nlm.
The vehicles clutch made a squeaking noise when engaged. The clutch failed and was replaced but the problem re-occurred within 10000 miles.
The car has died while engaging the clutch over five times. When we took it to Ford dealer they said they could not find a problem or that they could not recreate it. When the car dies you lose all power steering brakes etc, which in the right situation could be and is very dangerous. Now the car is off warranty so this is on;y route I knew to go. Something is wrong, other people have complained of same problem so it needs to be corrected.