Front Seat Belt Retractor problems of the 2000 Ford Mustang

The contact owns a 2000 Ford Mustang. When the contact removed his seat belt, he noticed that it did not retract. He feels this is a safety issue because the seat belt could fail in the event of a crash. The dealer stated that the retractor was failing. The contact refused to have the retractor replaced because the dealer refused to have the retractor investigated to determine why the failure was occurring. No repairs have been made. The contact called the manufacturer and was informed that no compensation would be provided because the vehicle was not under warranty. The failure mileage was 67,000 and current mileage was 68,000.

The contact owns a 2000 Ford Mustang. The contact stated that the driver side seat belt retractor has failed. The other three seat belts were repaired under a recall, however, the dealer stated that this failure is not covered. The purchase date, powertrain, and failure mileage were unknown. The current mileage is 80,000.

The driver and front passenger seat belts do not retract fully and therefore are safety hazards because there is too much slack.

: the contact stated both front seatbelts do not retract. Also, while the brakes are depressed, the seatbelts lock up. The manufacturer has been alerted.

My 2000 Ford Mustang seat belt wont retract. Called dealer about defect they said not one of cars on recall for this problem. They need to look into expanding the recall to cover more cars with this problem.

The passenger seat belt will not retract from the retractor. Any one riding in the passenger seat is left unrestrained. The dealer was notified.

Consumer complained that the front seat belts were stuck in the retractors. Dealer examined the belts and will not replace them for free. One of the belts broke a year ago, and the other one just recently.

Seat belt not retracting properly when trying to wear.

Consumer states that the passenger seat belt would lock up when brakes are applied in a sudden impact. Dealer notified. Feel free to provide any further information. Nlm.

Safety belt will not stay in retainer clip. Bad design.

I have been having a problem with my safety belt harness for several months now. I feel this is a safety hazard. When I start to latch my seat belt on the drivers side it will twist and I have to get out of the car and help it retracked. Sometimes it won't retrack properly and I have to wear it as is. When the belt isn't like it should be and if I apply my brakes to suddenly stop it won't catch like a seat belt is supposed to. I made an appointment on 12/18/2001 to have this problem fix and the dealership said it was checked and was found to be in normal operation. My car did not do this until a couple of months ago. I know this is not normal and I feel it is a major safety hazzard. I am a faithful seatbelt wearer and I feel very uncomfortable wearing this one. I understand that your company doesn't get in the affairs of the customer and the dealer; however this isn't the first time my car hasn't been worked on due to them not finding anything. I strongly feel that this isn't the way all Ford vehicles are structured. If that were true I would have had trouble with it a year ago not one year and 6 months later. I do not wish to cause problems for the dealership I am concerned with my safety when I drive. The passenager side seat belt is fine. Thank you for your time in reviewing my case. Audrey caldwell.

Rear ended - restraint provides no whiplash protection- I feel it fails to meet federal regulations.

The driver and passenger front seat belts will not retract or may not come out of the retractor. Driver states "front passengers are not able to fasten their seat belts".

The seat belts failed to retract.