Three problems related to brake master cylinder have been reported for the 2010 Ford Taurus. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2010 Ford Taurus based on all problems reported for the 2010 Taurus.
Tl the contact owns a 2010 Ford Taurus. When the brake pedal was depressed, it traveled to the floorboard on more than one occasion. The vehicle was diagnosed and kept for over a month by haldeman Ford (640 us-130, east windsor, NJ 08520, 609-448-0940). The dealer replaced the brake master cylinder, but the brake pedal still traveled to the floorboard. The vehicle was taken back to the dealer for diagnostic testing. The vehicle had an extended warranty; however, the dealer had not yet verified if the additional brake diagnosis and repairs would be covered by the extended warranty. The manufacturer was notified of the failure. The vehicle was not repaired. The VIN was not available. The approximate failure mileage was 62,000.
The contact owns a 2010 Ford Taurus. While driving approximately 30 mph, the brake pedal had to be depressed to the floorboard to stop the vehicle. The vehicle was taken to an independent mechanic and a dealer where it was diagnosed that the master cylinder was fractured and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 51,000.
The contact owns a 2010 Ford Taurus. The contact stated that while driving approximately 25 mph, the brake pedal traveled to the floorboard when engaged, however the vehicle did stop. The vehicle was taken to an authorized dealer for diagnosis. The technician replaced the master cylinder. In addition, the contact was advised that the hydraulic control module was faulty and would be replaced once the part became available. The vehicle remained at the dealer until further repair. The manufacturer was notified of the problem. The approximate failure mileage was 32,000. The VIN was unavailable. Updated 03/12/lj the abs module needed to be replaced. 03/21/14.