Two problems related to steering tie rod assembly have been reported for the 2002 Ford Windstar. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2002 Ford Windstar based on all problems reported for the 2002 Windstar.
At times when is col,d the abs and brake light is off while driving, when it gets hot the abs and brake light turns on and the abs fails to work. Code c1185 abs power relay output circuit failure. I got to a stop sign and the road was wet and the van skidded , the abs did not work. No one was hurt and I have seen all the complaints that Ford owners are having. I don't know if my 2002 Ford Windstar had all the other recalls done, like the brake pressure differential deactivation switch (scds) and the rear frame welds that are breaking up on the chassis of many Ford owners. I would like to verify what has been done to my Ford Windstar that I bought two months ago. I just had the inner and outer tie rod ends done along with the sway bar links at the front suspension.
The antilock brake system light as well as the traction control lights keep coming on. Garage can't tell the exact cause. The booster arm busted, keeping the brakes engaged as driven. The booster arm was replaced and the lights are still on. I reset it, and they reappear after a short time. I now smell the brakes when applied. I've had engine replaced at 101,000 miles, two transmissions, multiple brake jobs, rear axle repaired, front axle repaired, front tie rods repaired. The alignment on my vehicle could only be partially completed. . . . Toe, and another alignment done, but the complete alignment would need a hole drilled in the frame and a bolt moved over - bad design by Ford. I've also had to have the oxygen sensor replaced at my own expense. The vehicle is a ticking time bomb, piece of crap.