GMC Sierra 3500 owners have reported 3 problems related to brake sensor (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of GMC Sierra 3500 based on all problems reported for the Sierra 3500.
Brake failure due to rusted out brake lines, also on-going since truck was new with abs engaging at slow down due to corroded sensors.
See
all problems of the 2004 GMC Sierra 3500
🔎.
Anti-lock brake sensors on the front of my 2004 GMC 3500 dually diesel were malfunctioning creating extended low speed stops at a stoplight, causing many close calls in rear ending another car. . Read more...
The contact stated there was rust on the abs sensor on the front axle. The vehicle was taken to a mechanic, and they took the front hubs off and cleaned out the rust. The two abs sensors were also replaced. The vehicle was working properly at this time. There was recall, 05v379000, and this consumer experienced the same failure. According to general motors, this vehicle was not included in the recall due to VIN. The rotors were replacd due to rust. Updated 11/29/05.
See
all problems of the 2001 GMC Sierra 3500
🔎.