Honda FIT owners have reported 5 problems related to mid/rear seats assembly (under the seats category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Honda FIT based on all problems reported for the FIT.
2008 Honda Fit base model: floor of back seat and the cargo area behind back seat is wet, and is now growing mold. I have no idea how so much moisture/water is getting into the carpet. I am also concerned that the floors will rust as well. Seriously, Honda step up and issue a recall and fix this issue!! I will be filing a complaint with the ag's office!.
See
all problems of the 2008 Honda FIT
🔎.
This car was in an accident, it was rear-ended by another vehicle. This Honda Fit was stopped in traffic at a construction zone in suburban cary, nc when it was hit from behind by a small truck that was going approx. 45+ mph. The impact pushed the Fit forward into some construction materials. The truck driver was found fully responsible for the crash and was not injured. For the Fit, air bags inflated for the passenger side but none for the driver. Fortunately, the driver was the only person in the Fit. As shown in pictures (attached), the driver' seat tipped backwards from it's upright position. The head rest completely fell off and ended up in the back seat, giving the driver minimal protection. In addition, a metal bar under the driver's seat was thrust forward, causing a deep and large hematoma in the driver's leg.
See
all problems of the 2013 Honda FIT
🔎.
Water is leaking and causing rust in the cavity where the spare tire sits. According to online research, this is common in the 2007-2008 Honda Fit. The water runs down along the inside panels and pools in the spare tire cavity. This has caused the spare tire and jack to become completely corroded and rusted. Water then spills from that cavity to the foot space of the back seat. The carpet becomes water logged. The seats, when folded down, become wet. The supports for the seats are rusted.
See
all problems of the 2007 Honda FIT
🔎.
The first time I noticed a problem was in Feb. 2014 when I entered my vehicle there was frost on the inside of my windshield. Since then I have been having frost or moisture on the inside of my windows when I enter my vehicle in the morning. I have had to vacuum the back floor on both sides after every rain storm. Mould is forming on the carpeting and the back seats. My main concern is my 5 & 7 year old grandkids who I have to transport to and from school. Honda doesn't seem to want to address this problem. There doesn't seam to be a fix for this problem when I have check various web sites. I ran a test this morning by running water from a garden hose over the top of my Honda. I could see water running from the underside of both rear doors into the rear floors.
The contact owns a 2007 Honda Fit. While buckling his grandchild into the back seat, the contact realized that the seat bench in the rear was raised. He believes this is a safety defect because if the vehicle were rear-ended, the seat would jump and cause the booster seat and child to be uprooted. He took the vehicle to the dealer and they compared it to three other new models, which were manufactured in the same manner. The dealer was unable to diagnose the cause of failure. The VIN, engine size, and number of cylinders were unknown. The current and failure mileages were 11,000.
Problem Category | Number of Problems |
---|---|
Seats problems | |
Front Seat Head Restraint problems | |
Mid/rear Seats Assembly problems | |
Front Seat Heater/cooler problems | |
Seat Broken problems |