Structure Problems of Hyundai Genesis

Letter from congressman sarbanes on behalf of constituent re vehicle safety. The consumer stated there was a metal-on-metal sound coming from the vehicle and the steering would bind while driving. The vehicle was taken to the dealer, where the noise and steering issues were confirmed. The dealer stated the problem was due to a seam failure on the chassis. The steering pump was replaced. However, a month later, the problem returned.

See all problems of the 2011 Hyundai Genesis 🔎.

2012 Hyundai Genesis. Consumer writes in regards to defective unibody the consumer stated she heard a squeaking noise coming from the side of the vehicle when driving on side roads at 5- 30 mph. The dealer stated the cause was from poor welding on the unibody brace of the vehicle. The dealer was not able to repair the vehicle, nor had they ever seen such a robotic weld defect on any other vehicle they serviced before. Therefore, they had to send the vehicle to a body shop, to drill out and re-seal the body seam and re-finish it.

See all problems of the 2012 Hyundai Genesis 🔎.

The 2010 Genesis coupe hood is misaligned on the driver side. The gap is about 1/4" wider on the driver side as compared to the passenger side. This allows more air to enter the hood compartment. The wind buffeting effect vibrates the hood and could create an unsafe situation if the hood opens up at high speed.

See all problems of the 2010 Hyundai Genesis 🔎.