Nine problems related to wiring have been reported for the 2014 Hyundai Sonata. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2014 Hyundai Sonata based on all problems reported for the 2014 Sonata.
Drivers side brake light bulb exploded, and melted into the socket. I was advised that you cannot replace just the socket and Hyundai is quoting $400 for the entire wiring harness. This is a fire hazard and causes an additional safety hazard with the loss of the brake light.
Taillights constantly burn out and work inconsistently. My passenger side taillight currently does not work after the entire taillight connector/wiring harness has been changed due to the bulb burning and melting the socket. The fact that the light gets hot enough to melt thus piece is a fire hazard. Additionally my esc light goes on for days and then suddenly goes off. I don't believe it possesses a safety issue due to possible unpredictable malfunctioning.
In 2018 I started periodically to smell an electrical burning odor while driving my car. My driver's side headlamp went out. I replaced it on Saturday with replacement part from autozone. Sunday that bulb went out. Took to dealership 4/24/18, they replaced it-hasn't gone out again. Smelled burning again. Received police ticket for driver's side taillight out. Took to dealership 6/26/18, explained smell. Verified wiring assy/socket was burnt up & bulb melted to socket. Called Hyundai cs because they wanted me to pay for repair, explained periodic burning smell. Hyundai replaced harness & bulb, no charge to me. In June & July 2019, I had been told by unhappy motorists, you have no rear lights &/or brake lights. Took to dealership 7/19/19 explained burning smell. Was told passenger brake light burnt out. It was replaced, I was charged $44. 84. They said nothing about smell. Not being happy with the service dept not addressing the smell, I called Hyundai cs again. A case was opened. Took car to different dealership for diagnostic per Hyundai case. They only did the rearend, tech said they had known issues on this. Both sides were found to have burnt up wiring assemblies again that need to be replaced. Tech reported to me that the last tech at the other shop would have seen this issue at the time they replaced the bulb, if they replaced it! Hyundai gave me 2 options; they pay parts & labor-no warranty on either, or they pay parts & I pay labor for 12 month/12,000 mile warranty. I am paying labor for warranty. There are numerous reports online regarding this same issue. I will live in fear of my car burning up with/without me in it. Or god forbid being in an accident for rear lighting failure which could result in injury or death to myself and/or others. This issue needs to be fixed by Hyundai and a recall & extended warranty time granted due to manufacturing problems!.
Purchased a Hyundai Sonata 2014 Nov 2016. Are very serious issues with interior and especially with exterior lighting, brakes lights, rear lights. Break lighting assembly and wiring harness melts and burns to a black crisp, bulbs burst due to severe overheating during "normal operation" of the vehicle. Safety and fire hazard with rear tail light lap assembly, bulb burns extremely hot right through plastic housing unit. Unable to replace bulbs because lighting assembly melts to the socket's core and the socket melts over the bulb metal base. Expect extreme damage prohibiting replacement of any bulbs. After being pulled over repeatedly, informed exterior lights were even after just changing them. . Light bulbs burn hot rapidly, melt to the socket make it unable to get any replacement light bulbs to work because entire unit is then damaged, burnt and melted. Bulb will not fit because plastic unit has melted from circular to inward. Lights fail without the owner ever knowing until its too late. I've been parked at mall police officer informed me light was out, driving on highway pulled over 7 times given warning, repair orders due to lights out, pulled over on side street, road and lights just go out on highway. By the time bulb goes out its burned the entire unit through wiring, anything touching or around it. Change lights every 2, 3 weeks. When changing them I notice damage worsening, metal and bulb are burnt to a crisp. When I replace on side, a week or two later I have to change the other side. Creating a trickle affect. Once one goes out. Another goes out and so fourth. You literally have to replace the entire housing unit which is very expensive. Same repeats. . Tried to replace bulb with a halogen bulb instead and the base and bulb also burned. . Under assumption that doesn't burn hot. Did not work. During severe rain pre-existing issues only worsen and magnify. .
Since owning this car I have replaced the head lamps about ever 2-6 months. The next issue that is worse than the head lamps is the tail lamps. When the tail lamps burn out they melt into the housing so you can not just change the bulb you have to change the entire wiring harness. This first happened on the drivers side and now on the passenger side. Called the dealer and they have no wiring harnesses in the state closest one is in ohio.
Break lighting assembly and wiring harness melts during normal operation. Unable to replace bulbs because lighting assembly melts to the socket or the socket melts over the bulb metal base. This causes break lights to fail without the owner knowing. Which could result in accident due to no break lights also the traction control system can be effected by this short by shorting out the break light relay.
The left rear light keeps burning out very quickly. The housing has had to be replaced and the bulb was difficult to take out, like it was melting to the housing. The bulb looked burnt. Also, both my headlights will not turn on normally, I have to turn on my bright lights in order to have any lights at all, and when I turn on my blinkers, the lights turn off and I have to quickly adjust to turn them back on. It if very dangerous! there seems to be a short in the wiring because the left rear light, the back license plate light, the washer fluid button, and the front lights do not work properly. They all seem to have quit working or intermittently quit working at the same time. I have gotten stopped by the police a few times and given warnings because of my dim or randomly non-working lights. This is extremely dangerous and terribly frustrating.
The left rear light where I place the bulb is burned out. The housing of where the bulb goes has to be replaced. Also, both headlights where I replace the bulb has burned out and needs to be replaced. There is a shortage in the wiring in the rear lights.
The back lights are going out extremely to often. I have to change them out at least once a month and when changing them I notice that the bulb is black, almost like they are burning out. When I replace on side, a week or two later I have to change the other side. It seems to be a wiring issue.