Front Suspension Control Arm problems of the 2006 Hyundai Tucson

Two problems related to front suspension control arm have been reported for the 2006 Hyundai Tucson. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2006 Hyundai Tucson based on all problems reported for the 2006 Tucson.

1 Front Suspension Control Arm problem

Failure Date: 10/20/2020

I just spent about $100. Fixing ball joint and control arm and was rotating wheels and looked under car and seen rear subframe all rusted out. The car has a great body and runs very good. I bought this car brand new and I drive my grandkids in this car and now looks un safe to drive.

2 Front Suspension Control Arm problem

Failure Date: 05/02/2012

The contact owns a 2006 Hyundai Tucson. The contact stated while driving 15 mph the passenger front tie rod and control arm failed. The vehicle was towed to a local mechanic. The local mechanic stated that the failure was a common failure. The manufacturer was made aware of the failure. The contact stated the failure was due to a defect in the material. The vehicle was not repaired. The failure and current mileage was 72,000. Updated 07/05/lj.


Other Suspension related problems of the 2006 Hyundai Tucson

Suspension problems
6
Front Suspension Control Arm problems
2
Rear Suspension problems
1


Safety Ratings of Tucson Cars
Fuel Economy of Tucson Vehicles
Tucson Service Bulletins
Tucson Safety Recalls
Tucson Defect Investigations