Adaptive Cruise Control problems of the 2018 Jeep Grand Cherokee

The contact owns a 2018 Jeep Grand Cherokee. The contact stated while driving 60 mph, the traction control warning light illuminated. Additionally, the contact stated that the vehicle would start and shift out of park without depressing the brake pedal. The brake warning light was illuminated. The contact stated that the adaptive cruise control mode and the automatic start/stop feature were no longer operative. The contact received notification NHTSA campaign number: 22v426000 (service brakes, hydraulic) however, the part to do the recall repair was not yet available. The vehicle was taken to the local dealer where it was diagnosed that service brake hydraulic system had failed. The vehicle was then taken to a second dealer, bryden Jeep ram Dodge Chrysler - bryden motors (548 broad st, beloit, WI 53511) who provided the same diagnostic result and advised the contact to not drive the vehicle as it was unsafe. The contact stated that several unknown warning lights would illuminate while driving the vehicle. The vehicle was not repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure but provided no assistance. The failure mileage was approximately 48,000. VIN tool confirms parts not available.

Where to start. Display module glue is falling apart. Can no longer use my screen due to poor glue adhesion. All adas systems malfunctioning: fcw, lka, automatic emergency breaking, blind spot warning, acc, rear cross traffic warning systems do not work. Overall bad build quality and cannot use safety features.

The uconnect system laminate bubbles and as such, the system has a phantom buttom touch every few seconds. While driving, this results in an audible ding, the navagation no longer is visible, you are unable to use the backup cameras. I have also been in a situation where it turned on the seat and steering wheel heating and I was unable to turn it off. This is a very wide spread issue and is an incredible safety hazard when driving. It effectively makes it not possible to control the electronics of the vehicle while driving. I urge anyone reading this who does not think this is a huge issue to try driving one of these vehicles while this is happening. I used to drive over 20k miles a year with my previous vehicle. This issue started a month after I bought this vehicle from vroom. As such, I have driven less than 1,200 miles in 18 months. I am incredibly surprised that this has not been recalled yet. I am trying to upload a video of it but it will not let me. This is a major problem.

While using the acc function and setting forward distance at any length the problem is that when the car in front of you slows, stops,,or turns my vehicle will brake on its own. However, while braking during the mentioned operation the big problem is that the brake lights do not illuminate. I have had several close calls with someone nearly running into the back of my vehicle during the use of the adaptive cruise control (acc). This can be extremely dangerous if you are now fully aware of this problem. This should have been addressed during the acc hazardous examination phase. A very simple fix would be to install an I/p switch in the brake line at the master cylinder so that the pressure from the acc applying the brakes sends the pneumatic signal to an electrical signal that lights up the brake lights. This problem should absolutely have been caught and addressed during the design phase. I found out when I asked a service manager about it and he said the lights do not come on. He also said they know about it.