Brake Light Problems of Jeep Renegade

The contact owns a 2017 Jeep Renegade. The contact stated that while driving at an undisclosed speed, the message "left brake light failure" was displayed. The contact disassembled the rear driver's side brake light and discovered that the wiring harness, turn signal, and brake light were melted. The vehicle was taken to the dealer, but the vehicle was not yet repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 122,000.

See all problems of the 2017 Jeep Renegade 🔎.

The connector to the brake lights (where the wires meets bulbs) melted and has caused my right rear lights to malfunction. I was told the warehouse the part was ordered from had 8 of the parts in stock and that it wasn't normal for that many to be available.

See all problems of the 2016 Jeep Renegade 🔎.

Got into Jeep to go home from work and I look down the screen is telling me my left signal, parking light and brake light is out. The next day it was working fine. A few days after that it did it again will I was driving this time the little light on the bottom right corner of the screen popped on and caught my attention,so I changed all the bulbs and still nothing so I check fuse it's good. Take to shop and find out the connector shorted out and the wires were corroded. This is a safety issue because had I not been paying attention and had my husband double check and make sure it wasn't working I may have never found this problem. The first time it happened was Tuesday September 3rd and the second time was Thursday September 5th.

See all problems of the 2015 Jeep Renegade 🔎.