general problems of the 2010 Jeep Wrangler

Two problems related to visibility have been reported for the 2010 Jeep Wrangler. The most recently reported issues are listed below.

1 Visibility problem

Failure Date: 03/16/2012

Tipm is creating a major safety issue with my 2010 Jeep Wrangler. On multiple occasions, the headlights fail to work on my vehicle on start up or once the vehicle is in operation. The dealership looked at the Jeep and stated the tipm module was bad and needed to be replaced. The part was indefinitely on backorder from Jeep, and could not even be replaced if it were under warranty. Driving this vehicle that is under 2 years old and has a major safety issue is unacceptable. This appears to be a wide spread issue for a number of years with the tipm module on Jeep / Chrysler vehicles. This will happen to someone while driving at night without their knowledge, and create a deadly event. Would like to see Chrysler take responsibility for this dangerous situation and correct the issue to protect the safety of the missions of people driving their vehicles.

2 Visibility problem

Failure Date: 12/17/2011

The contact owns a 2010 Jeep Wrangler unlimited. The contact stated that that when using the heat, there was no heat coming from the driver's side vents. The vehicle was taken to the dealer who advised the contact that they would replace the heater core and flush the engine block. The manufacturer was notified and a claim was filed. The failure mileage was 17,800 and the current mileage was 20,000.


Other Visibility related problems of the 2010 Jeep Wrangler

Wiper problems
8
Windshield problems
3
Visibility problems
2


Safety Ratings of Wrangler Cars
Fuel Economy of Wrangler Vehicles
Wrangler Service Bulletins
Wrangler Safety Recalls
Wrangler Defect Investigations