Sway Bar Problems of Kia Motor Sorento

The contact owns a 2005 kia Sorento. When the contact's vehicle was taken to a dealer for repair, it was discovered that the rear axle sway bar brackets were severely rusted. The vehicle was not repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 119,000.

See all problems of the 2005 Kia Motor Sorento 🔎.

Vehicle is only 7 years old. Metal bracket welded to the rear axle that holds the upper control arms has completely failed! the normal torque from the rear axle has broken both brackets holding the upper control arm to the cars frame. All that is holding the rear axle in place is the lower control arms and the sway bars. There are no weep holes to allow water to drain out of the bracket weldment, causing water to fill the cup-like condition created. This condition has (an will) cause premature failure of all kia Sorento rear axle/upper control arm connections. While driving the rear axle could become detached from the vehicle due to excessive stress placed on the remaining parts. A typical traffic maneuver could cause a catastrophic failure, and render the vehicle uncontrolable, with the likelyness of massive pain, injury and death as a result!!! this is an extremely dangerous condition!!! these cars need to be recalled now before someone is killed!!! ps if you see a kia Sorento on the freeway. . . Stay away from it for your own safety!.

See all problems of the 2004 Kia Motor Sorento 🔎.

Vehicle is only 8 years old. I constantly have this problem. The first time I had this problem I slid while trying to hold brakes, there was also a lot of weird sounds and the rear end did not feel sturdy. I took it to my mechanic and he found metal bracket welded to the rear axle that holds the upper control arms had completely failed! the normal torque from the rear axle was broken both brackets holding the upper control arm to the cars frame. All that is holding the rear axle in place is the lower control arms and the sway bars. There are no weep holes to allow water to drain out of the bracket weldment, causing water to fill the cup-like condition created. This condition has (an will) cause premature failure of all kia Sorento rear axle/upper control arm connections. While driving the rear axle could become detached from the vehicle due to excessive stress placed on the remaining parts. Regular driving could cause a catastrophic failure, and render the vehicle uncontrollable, with the likelihood of massive injury and possibly death as a result!!! he also said that it cannot be repaired. This is a huge problem for me because I still have a car note to pay. This is an extremely dangerous condition!!! these cars need to be recalled now before someone is killed!!!.

Front end began excessive shaking on interstate at 65mph. Almost lost control, but managed to avoid a crash. The same shaking happens anytime I drive over a bump in the road on the right front tire now, but first problem happened at interstate speed. I have to pull over and stop moving to stop the shaking. Happens at all speeds now. Car is at kia dealer to replace sway bar link. Very dangerous condition, especially at interstate speeds. I contacted kia consumer department. They were not receptive to the problem.

See all problems of the 2006 Kia Motor Sorento 🔎.